answersLogoWhite

0

first you removee the trim pieces in the trrunk. then there shuld either be some wing nutts or actual bolts behind where the lightss are . remove those and the whole asemboly should come out

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you change the brake lights in a 1993 Ford Thunderbird?

Entire assembly should unbolt and slide out giving access to the bulbs


How do you change rear brakes and rotor on 1993 Lincoln town car?

Remove the tire and wheel from your 1993 Lincoln Town car . Remove the brake spring and break caliper. Remove the brake rotor by tapping on it with a hammer or mallet. Slide the rotor off. Reverse the process to install the new rotor and brake pads.


Where is the fuse block for the brakes on your 1993 ford ranger brake lights do not work?

the fuse panel on my 98 is on the left end of the dash. open the door to see it. my brake lights stopped working but did not blow the fuse. had to change the brake switch located on the brake pedal. good luck


Why do your brake lights not work but your tail lights do and all the fuses are okay in your 1993 Toyota Camry wagon?

Brake light switch ?


Why no brake lights on a 1993 Honda prelude but the running lights stay on all the time.Bulbs are fine .?

The brake lights may not work on a 1993 Honda Prelude if the brake light switch is no longer working. The brake light switch is in the steering column just above where the brake pedal is bolted to it. There is also a chance that a brake light fuse is blown.


How do you change brake pads on a 1993 Lincoln mark viii?

Front brakes are done the usual way but the back pistons have to be screwed into the calibers not pushed in.


Where is the multifunctional switch located in a 1993 Lincoln Marc viii?

the turn signal handle is made to the multifunction switch. It operates the turn signals, brake light, emergency lights, ect. drl


Why do the brake lights remaim on on a 1993 kenworth t800 when shut off?

Jammed brake switch or short in the circuit.


1993 Lincoln Town Car brake apportion valve adjust?

There is no adjustment.


What fuse controls the brake lights on an 1993 topaz?

The brake lights on a 1993 Topaz are typically controlled by the fuse labeled "STOP" in the fuse box. The fuse box is usually located under the dashboard or in the engine compartment. If the fuse is intact and the brake lights still do not work, you may need to check the brake light switch and bulbs.


Why do brake lights on 1993 Toyoya Camry wagon not work but the taillights do and all fuses seem to be okay?

The brake lights are a separate circuit from the tail lights. If the bulbs and fuse checks okay, I would suspect the brake light switch is at fault.


How do you disengage the park brake on a 1993 Lincoln Continental executive series?

your brake system is a good one because you have to push the brake to disengage it, as if it was on a spring.