Take the trans out, the clutch is inside the trans ^_^
its a ct26
If they are square, YES!. If they are round, NO!. In 1989, Toyota did a mid year crossmember/engine mount change. The square ones will fit '86 to '89. The round ones will fit '89 to '92.
To change the clutch on a 1989 Toyota Corolla, start by disconnecting the battery and removing the transmission. This involves lifting the car, removing the wheels, and detaching the drive shafts. Once the transmission is out, unbolt the old clutch from the flywheel, clean the flywheel surface, and install the new clutch disc and pressure plate. Finally, reassemble the transmission and drivetrain components, ensuring everything is properly aligned and secured.
A 1989 Toyota Supra Turbo typically requires about 4.5 quarts of oil when using an oil filter change. It's always best to consult the owner's manual for the most accurate specifications and recommendations based on your specific model and engine condition.
153624
there is a joint AT THE BOTTOM OF THE CLUTCH AND A BOLT U TIGHTEN THAT AND U ARE DONE I DID IT TO MY TRUCK
Take out the transmission
by your clutch pedal but far left attached to your inere wheel well
Toyota hiace has one common fluid reservoir for both brake and clutch system. it is located left lateral side of dash, it can't be seen when front left door is close.
The clock in my 1989 toyota van soes not work. What can be the problem?
If it has stretched to the point where you can't disengage the clutch any more that would be a good sign, also if it breaks of course.
In the 1989 Toyota MR2, the drain plug for the clutch is located on the transmission housing. To access it, you'll typically need to look for a small bolt or plug on the bottom or side of the transmission unit. It's important to ensure the vehicle is securely lifted and supported before attempting to drain the clutch fluid. Always refer to the vehicle's service manual for specific details and procedures.