Want this question answered?
how do i change front interior light for lexus rx 300 2004 model
Pry the dome light cover off with a small screwdriver.
You can replace the dome light bulb in a 2002 Chevy Cavalier by first prying the dome light cover off of the light. Then, remove the bulb and replace it by twisting the bulb from the socket.
a relay does not control both dome light and the radio.
If the dome light will not shut off on a 2002 impala, check for a water leak in the roof that might interfere with the operation of the light. Also check for a bad connection with the ground wire or a short in the wires.
it is located on the light a switch that says 12sec on and off
To replace the dome light in your 2005 Toyota, you will need a flat screwdriver to remove the screws and pry the dome light cover from the light. You can then access the light to change the bulb or replace the entire bulb and cover.
The auto dimming type you remove the dome light bracket, slide a thin shim in from the rear and push the clips that hold the dome light to the roof liner. pop the cover off the front of the dome light above the mirror, there are three torx head screws to remove. then the unit should come out. there is a bolt on the mirror bracket that needs to be taken off and then the wires on the back of the mirror are just pull the plug and re-plug the new one. do the re-install just backwards and before you know it your done.
looked at the fuse panel in the car and under the hood and it doesn't even say where the fuse for the dome light is. How stupid is this?
You can buy special mirror glue for it. I don't think it is glued. If It is the same as my 2001 Prelude, you must remove the dome light cover by prying it off at the front, then remove the Dome Light assembly by removing the two screws. After removing the Dome Light, you must pry off the plastic piece that surrounds the Dome Light. Be careful. There should now be a triangle shaped piece. Remove it by removing the 3 screws. There will be a loose washer. On the rear view mirror assembly that came off, there's a screw in the center of the end opposite to the mirror end. Remove screw. Assemble that end to the triangle part by inserting screw thru the metal washer that was loose. Tighten screw finger tight. Replace the mirror by attaching the triangle with the 3 screws. Replace the plastic surround piece and replace Dome Light and Dome light Cover. Hope that helps
light bulb out on map light how to change with out breaking plastic lens
Remove the pastic dome light cover and there are some small screws that need to be removed and the whole unit will be in you hand.