Want this question answered?
== == == == == == == ==
No
use your hands Xd
you must first detatch all wires
http://www.installdr.com/Harnesses/Mitsubishi-Wiring.pdf
If it is not a factory stereo, you will need a GM class2 data bus interface device in order to keep other car devices active.
To install an aftermarket stereo in a 2003 Montana you need to first buy a trim plate or a mounting bracket. Remove the dash panel. Disconnect the ground cable from the battery. Remove the factory stereo. Unplug the factory wiring harness from the radio. Connect the new radio. Test it and reassemble the dash. Reconnect the negative battery terminal.
yes it does is the same from 1999 to 2002 they change on 2003 and up
timing is set by pcm, at factory!!
You should be able to find it under the front passenger seat.
2003 Jetta Monsoon Premium Wiring Schematics: http://www.modifiedlife.com/2003-volkswagen-jetta-car-stereo-wiring-schematic-for-monsoon-audio/ 2003 Jetta Factory Wiring Schematics: http://www.modifiedlife.com/2003-volkswagen-jetta-car-audio-wiring-diagram/ ..hope that helps you out some
Here is a step by step tutorial for a 2004 Forester.Just copy the link below.http://www.computerizedmachining.com/remove-stereo-2004-Subaru-Forester.htmlThat site will help anyone remove the factory stereo from a 2004 Subaru Forester. This site has Photos and written instructions to make sure you can get the job done right. This site also has NO ADs, No Registration required.