0
Remove wheel, fender. Remove Allen bolt at bottom of fork with impact wrench, it usually will not come loose, if you are trying it by hand unless you stick the special tool down into the top of fork tubes. (I use a broom handle), remove dust seals on fork legs, remove circlip, carefully remove oil seals, replace them, and reverse procedure for reassembly, add oil to fork tubes.
Bubba
What else can I help you with?
How do you change fork seals on ktm 250 sxf 2007?
To change the fork seals on a 2007 KTM 250 SX-F, start by removing the front wheel, brake caliper, and fender. Next, detach the fork from the triple clamps and use a fork seal driver to remove the old seals after disassembling the fork. Clean the fork tubes thoroughly, install new seals with a seal driver, and reassemble the forks, ensuring proper oil levels. Finally, reinstall the forks onto the bike and check for leaks.
What is hp for virago 250?
Virago 250 has 22 hp
DOes virago 250 have kick start?
nope.
Why is your Yamaha virago 250 blowing fuse?
Which fuse is blowing? Yamaha XV250 Virago Manual Cyclepedia.com
Where is the oil drain plug on 1995 Yamaha virago 250?
It should be on the left under the gear change, it'll probably be like a little bolt.
Oil capacity of a 2005 Yamaha virago 250?
1,5 l
Has the 250 virago have a kick-start?
No, if you can't start it just run with it.
What type of oil do you use for a 06 virago 250?
rotella t6
How much horsepower does the 2007 Yamaha Virago 250 have?
21 horsepower
What is the horsepower rating for a 2007 Yamaha Virago 250?
21 hp
How much oil do you put in a 1994 Yamaha virago 250?
The 250 virago holds 1.9 quarts of oil total. This includes the oil in the filter. The system holds 1.5 quarts not including filter.
Why is your 1988 Yamaha virago 250 pouring oil from the crankcase vent hose?
Your 1988 Yamaha Virago 250 pours oil from the crankcase vent hose because of a disconnected crankcase vent line.
