Well.....I just finished doing it myself. I saw the official instructions from a GM website and said you gotta be kidding me. You are supposed to remove the entire front bumper etc. I found a shortcut, well sort of. Remove the inner fender well cover and then you can remove the light assemble from underneth and replace the bulb. The cover is attached with a bunch of push on body clips, pry the button up with a screwdriver and pull out fastner. Then there are two screws holding the light assembly on the bottom and inner side, it clips into the bumper on the outter side. From there it's pretty simple. FYI the GE replacement cross reference is wrong it's a Sylvania 3757A LL bulb. Good luck and take it slow.
How do you replace a front turn signal bulb for a 2000 sts cadillac?"
THE TURN SIGNAL SWITCH IS BEHIND THE PANEL UNDER THE STEERING WHEEL THERE ARE 2. ONE IS THE TURN SIGNAL AND THE OTHER IS THE FLASHER.
No
Push in and turn.
not sure
The turn signal flasher on a 1988 Cadillac is located under the dash on the driver's side of the vehicle. It is just above the brake pedal.
you need a offset needle nose pliers.it took me about a half hour
in the steering column
by pulling up on the turn signal switch
how do you change a rear turn signal bulb on a 2010 buick lucerne
Fuse #7 is the turn signal circuit. 10 AMP. 2nd fuse fron the left in the 2nd row from the top.
Above the fuse box that is located in the cab in fron of the driver door