Flasher unit.
there's a hazard flasher on your dashboard on top of your stereo where you turn on your emergency lights on.that flasher comes out with a thin screwdriver just pull it out and unplug it then plug it back in that would solve your problem if not that's that flasher you need to replace new
To change the turn signal on a 2007 Audi A4 Quattro, first, open the hood and locate the headlight assembly where the turn signal is housed. Remove the cover or any necessary fasteners to access the bulb holder. Twist the bulb holder counterclockwise to remove it, then replace the burnt-out bulb with a new one, ensuring it's securely fitted. Finally, reassemble the assembly and test the turn signal to confirm it's working properly.
To change the turn signal light on a 2003 Audi A4 Quattro, first, open the hood and locate the headlight assembly. Remove the appropriate cover or access panel to reach the bulb holder. Twist the bulb holder counterclockwise to release it, then pull it out and replace the old bulb with a new one. Finally, reassemble the holder, close the access panel, and test the turn signal to ensure it’s working properly.
go through the trunk
most audis have the turn signal flasher relay combined with the hazard pushbutton switch in the dashboard. You can pull the hazard switch out of the dash by gently prying it (it's held in by friction, no screws), disconnecting the wiring harness and replacing with a new part.
They signal that a chemical is replacing the oxygen the user is breathing
the switchover
the switchover
The turn signal on your 2002 Audi Quattro may start and stop due to a few common issues. One possibility is a faulty turn signal relay, which controls the blinking of the lights and may need replacement. Another reason could be a poor connection or a burned-out bulb, which can disrupt the signaling function. Additionally, the turn signal switch itself may be worn or malfunctioning, affecting its operation.
IF, the bulb doesnt light up at all than it is the turn signal balb but if the turn signal is flashing quickly, but still lights up like it should than it is quite possibly the turn signal phuse. And you need to check the phuse instead of thte bulb.
in my 2001 A4, it was the hazard light switch that had to be replaced. maybe thaqt's your issue also
Defective turn signal switch.
yes it will cause it doesnt use the signal to set the alarm or time.