With the car on level ground, in gear and parking brake applied, loosen the wheel nuts a half turn. Get the jack out, make sure to find the right spot for the jack to engage the car. Make sure that the ground is firm and flat where the jack will stand.
If you have them, put chock blocks ahead and behind the wheel diagonally from the one you're going to remove.
Jack the car up until the wheel clears the ground.
Undo the wheel nuts the rest of the way.
Pull the wheel off.
Put new wheel on.
Tighten the wheel nuts enought to seat the rim on the hub properly. Lower the car back on to the ground. Do the wheel nuts up real tight in a cross-wise pattern.
Done!
With fabrication and lots of $$$ anything is possible.
Change to a RWD chassis
To pay someone to do this job would not be cost effective. Better to buy a rear wheel drive vehicle and sell the front wheel drive vehicle.
Like you change the tires on any other car...
They are front wheel drive.
Sounds like to me you need a wheel bearing
In order to change the front wheel bearing on a Nissan X-Trail, one must remove the hubcap from the tire, thusly remove the tire from the car's axel, and then feel around for the wheel bearing and dislocate it.
how do you change front wheel bearing for 420 rancher
No. It is a front wheel drive car.
front wheel they can be change to rear wheel theu can be changed but mostly front wheel drive
Depends on the car front wheel drive it a cradle rear wheel drive it a sub frame.
Yes , it's front wheel drive