answersLogoWhite

0


Best Answer

Your fuel filter should be located next to your engine in the engine bay. To the passinger side of the engine. It should have one plastic clamp on each end of the filter. Squeeze the clamps on both sides with a pair of pliers and pull the fuel line away from the filter. Then remove the clamp holding the filter to the wheel well. Do everything in reverse to install your new filter.

User Avatar

Wiki User

โˆ™ 2006-10-07 13:02:50
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the fuel filter on a 1987 Nissan 200SX?
Write your answer...
Submit
Related questions

What is the oil capacity for a 1987 Nissan 200sx?

The engine oil capacity for a 1987 Nissan 200SX is: 3.8 quarts for a 4-cylinder 4.0 quarts for a V6


How do you change a fuel pump on a 1987 Nissan 200sx?

drop the gas tank...pull the fuel mod out and replace the pump


Where can you buy a right rear taillight assembly for a 1987 Nissan 200SX?

At a Nissan dealer or a junkyard.


What is the spark plug gap for a 1987 Nissan 200sx CA18ET turbo?

The Nissan FSM says: 1.0mm-1.1mm


How do you change a transmission filter on a 1987 Nissan maxima?

Does not have a filter. There is a screen in the transmission which generally needs no service.


How do you replace the starter on a 1987 Nissan 200SX?

cant see bolt on other side off starter, how to replace it ?


Where is the starter located on 1987 Nissan pickup?

above the oil filter,to the left.


Where is the PCV valve on a 1987 Nissan hardbody Pickup Z24i engine?

On a 1987 Nissan Hardbody Pickup, the PCV valve is located between the alternator and the oil filter. The valve can be seen when the oil filter has been removed.


Where is the flasher unit on a 1987 Nissan 200SX?

put your car in "accessory" and turn on a blinker. You will hear the flashers noise on the stearing column under the dash


Where is the PCV valve located in a 1987 Nissan Sentra?

You can find the PCV valve for your 1987 Nissan on top of the engine. The PCV valve will be near the air filter housing.


How do i change the yoke on my 1987 Nissan pickup?

nose


1987 Nissan truck 4x4 where is the starter located?

above the oil filter ,to the left.


How do you disconnect the alarm system in a 1987 Nissan 200sx?

Under the front passenger seat, there is an electrical harness. Simply unplug the connection. This should disable the alarm.


How fast is a 1986 Honda 200sx?

I have a 1987 Honda 200sx and it does between 50 and 55 stock


Where is the oil sending unit on a 1987 Nissan truck engine located?

above oil filter.


How do you change a fuel injector in a 1987 Nissan maxima?

Where is the fuel injector located?


What is the engine oil capacity of a 1987 Nissan D21 Pickup?

4 quarts w/o filter 4 1/2 quarts w/ filter


How do you disconnect the drive shaft to slide the transmission back so you can replace the clutch plate in a 1987 Nissan 200sx 3.0 6-cyl?

Disconnect the driveshaft at the rear end and pull it out of the trans.


Where does the oil filter go to a 1987 Nissan Maxima Transmission?

If it has a servicable filter, it more than likely will be located inside the transmission. The transmission pan will need to be removed to access the filter. Look in your owner's manual.


How do you change the oil filter in a 1987 Mercedes Benz 190e 2.3?

Remove the air filter, And its located right in the back.


What the fuel pessure should be for an 1987 Nissan pup z24i?

It should be check after the fuel filter and it should be approximately 37 psi.


How do you change the radio fuse in a 1987 Nissan 300zx?

Remove the radio and the fuse is behind the radio


How do you change the fuel filter on a 1987 Camaro?

Find the 1987 Camaro fuel filter on the cars frame. Cover the connectors with a rag, and loosen them. Remove the filter, and put the new one in. Tighten the lines to complete the installation.


How do you push the brake cylinder back in on the rear brakes of a 1987 Nissan 200SX?

If the brakes are disk on the rear they can't be push or pressed in they have to be screwed in by turning the piston clock wise try this it should work. That is what I did on my 1994 Nissan Maxima becareful not to damage the rubber dust boot on the piston.


Does a 1987 Nissan Maxima have a cambelt or timing chain?

According to the Gates website , the 3.0 liter V6 in a 1987 Nissan Maxima : has a timing BELT , it's an interference engine , and change the belt at 60,000 miles