0
How do you change the fuel level sensor in a 2000 Impala?
Lolahamilton7
To change the fuel level sensor in a 2000 Chevy Impala, first close the gas and power lines. Remove the wiring and then drop the car tank. Remove the old fuel level sensor and replace it with the new one.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
2000 impala 3.4 stalls at low speeds?
I had a problem with stalling with a 2000 Impala, and it was the oxygen sensor.
Where is the knock sensor in a 2000 Impala?
front of engine neat oil filter
Pictures of crankshaft sensor on 2000 Chevy impala 3.8 liter v6?
Check
How do you install a throttle position sensor on a 2000 Chevrolet Impala?
You will need a volt meter to adjust the sensor and a lab scope to determine if you have a glitch in the sensor.
Where exactly is the 2000 Chevy Impala crank shaft sensor?
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft
Where is headlight sensor on 2000 impala?
On the 2000 Chevrolet Impala, the Head light sensor is on the inside dash board on the driver's side near the windshield and next to the vent. It looks like a small glass bubble.
How do you change a Camshaft in a 2000 Chevrolet Impala?
What size engine.
Where is the oxygen sensor on a 2000 Chevy Impala?
Probably just in front of, or on the front of the catalytic converter.
How do you change bulb on instrument panel of 2000 Chevy Impala?
you cannot service panel lights on 2000 impala . you hav to replace the instrument cluster.
Where is a 2000 VW fuel sensor?
The fuel level sensor? It will be in the tank.
How do you change the turn signal switch in a 2000 Chevy Impala?
it is cool
How do you change the crankshaft sensor on a 2000 Impala 3.4?
You have to pull the balancer and then you have 2 screws holding the crank sensor to the engine block.You will need a puller with 3 small fingers to get the balancer off.Be careful not to bend the tangs on the rear of the balancer.
