0
What else can I help you with?
How do you change plastic bumper cover on peugeot 306?
no se como cambiarlo
How do you remove a gear knob off a peugeot 306?
To remove a gear knob from a Peugeot 306, start by gently pulling upward on the knob while twisting it to loosen it. If it's stubborn, check for any retaining screws or clips that may need to be removed first. Once loose, simply pull it off the gear stick. If you're having difficulty, consult the vehicle's manual for specific instructions related to your model year.
Change heater matrix on 306?
is it difficult to change a heater matrix on a t reg puegeot 306 td
How do you change the fan belt on a peugeot 306?
fanbelt on a 306 hdi how do fit it
How do you stop peugeot 306 over revving when changing gear?
Try changing or cleaning out the stepper motor, this controls the idle and is a common fault on the 306.
Where is the reverse light switch on peugeot 306?
probably located on top of the gear box
Where is the reverse light switch on a peugeot 306?
probably located on top of the gear box
What are gear change speeds on a peugeot 306 diesel?
Depends on the engine, on the XUD (1.9 non turbo) the most economical point to change gear is when the speed is 10mph less than the gear number (eg. change to 3rd at 20mph) but for better acceleration changing at the same value (3rd at 30 etc.) will get the car moving quicker. There's no "official" details on this, so the best way is to see what works for you.
How do you change a thermostat on Peugeot 306?
really easy fix! what model 306 is it? regards, Simon
How do you change a indicator stalk on your 306?
how to remove indicator stalk and cowl from Peugeot 306 lx
Peugeot 306 1.4 XL 1995 what would be the most likely problem if the car started to jerk forward or kangaroo when you first change it into a gear Down or up the gearbox?
take it to a garage
How do you change the ignition coil on peugeot 306 hdi meridian?
To change the ignition coil on a Peugeot 306 HDi Meridian, first, ensure the engine is off and cool. Disconnect the negative battery terminal, then remove the engine cover if necessary. Unplug the electrical connector from the ignition coil, unscrew it from the engine, and replace it with the new coil. Finally, reconnect the electrical connector, reattach the engine cover, and reconnect the battery.
