Purchase a 9007 headlight. There are many brands; I prefer Sylvania. You must open the hood and at the rear of the headlamp there is a plug assembly. Take your hand and turn counter clockwise until the harness pops out. You will then take the old headlight out by just adjusting the clip holding it into place. Then you put the new bulb (9007) on the end of the harness until it clicks. Replace the bulb and harness into the hole in the headlamp and turn clockwise this time until it pops into place. It will fit snuggly. That's it turn on the key or headlights to see if it is working properly. Good Luck
To adjust the headlights on a 1999 Chevy Metro, park the car on a level surface about 25 feet from a wall. Turn on the headlights and mark the center of the light beams on the wall with tape. Then, using a Phillips screwdriver, locate the adjustment screws near the headlight assembly; one adjusts the vertical alignment and the other adjusts the horizontal alignment. Turn the screws until the top of the light beam aligns with the tape marking for proper adjustment.
Yes.
My 1999 Chev. Metro has fuel injection. I doubt that any of them were carbureted.
i need timeing marks for a 1999 1.3 chevy metro
It is by the rear wheel near the fuel tank.
The 1999 Chevy Geo Metro 1.0 liter engine PCV valve can be found on top of the engine. The PCV valve will be behind the air cleaner housing.
Yes it shoud fit. Geo metros had the same headlights from 1995 - 1999
Yes, my uncle has a Chevy lumina and the headlights are always on,its andomatic
For the 1999 Chevy Tahoe, automatic headlights are turned on by default. Turning them off requires opening the bezel on the dashboard and removing the light sensor.
u cant
The 1999 Chevrolet Geo Metro horn fuse can be found in the fuse box. The horn fuse will be in the second column, fifth from the bottom.
1995-2000 should all be the same