Want this question answered?
how to change a motor mount on a kia optima
Remove the wiring harness from the high mount brake light. Remove the back cover of the brake light assembly. Take hold of the brake light connector, push in and turn at the same time. Reverse the process to install the new brake light.
2007 Kia Optima center high mount stop (third 3rd brake light) bulb replacement: Purchase the correct replacement center high mount stop (third 3rd brake light) bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the center high mount stop (third 3rd brake light) bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. If there are multiple bulbs, you may want to consider replacing all at the same time in order to keep brightness and color equal (optional).
Remove the high mount brake light retaining screws from your Mazda Protg. Remove the high mount brake light wiring harness. Reverse the process to install your new high-mount brake light.
Remove the wiring harness from the high mount brake light. Remove the retaining screws. Reverse the process to install the new high mount brake light.
see owners manual. its easy to do
The way that you change a high mount brake light on a 2007 Taurus is by first prying the light assembly from the housing. You then push rearward to remove it from the retaining clips. Next, life the light assembly from the shelf and disconnect the assembly wiring. Replace the light assembly and reverse directions to put the light housing back where it goes.
Center High Mount Stop Lamp or CHMSL. It is also called a third brake light.Center High Mount Stop Lamp or CHMSL. It is also called a third brake light.
the brake light switch is located on the brake padal bracket just to the right of the steering column mount. you'll need to remove the left underdash sound panel beneath the steering column to get to the switch and connector.
Because you have a spoiler, Honda likely decided to not even include a light socket for the high mount brake light (behind rear window). It's because the spoiler fin blocks this high mount light anyways.Pop the trunk and check to see if a light bulb socket even exists for the high mount brake assembly. If a socket doesn't exist (and you don't see one hanging) then no worries, it was a Honda decision. This is the case for my 2000 Accord EX.
The B.O.O. switch or Brake On/Off switch is located at the top of the brake pedal assemble.
Just unscrew it.