0
Begin by removing the retaining ring at the top of your ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
Wiki User
∙ 2014-11-20 01:34:45
Add your answer:
Earn +20 pts
How do you replace an ignition switch in a 1993 infinity J30?
change switch
Replace ignition switch for 1993 Buick century?
Replace ignition switch for 1993 buick century?
Where is the fuel safety switch located on a 1993 GMC Vandura Van?
There is not one.
How do you change the ignition switch on a 93 Nissan quest?
Begin by removing the retaining ring at the top of your 1993 Nissan Quest ignition switch. Slide the ignition barrel out. Remove the wiring harness from the end of the ignition barrel. Reverse the process to install your new ignition switch.
How do you replace the ignition switch on your 1993 Chevy K 2500?
Remove the retaining ring at the top of your 1993 Chevrolet K 2500 ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
How would you know if a fuel relay is blown in a 1993 subaru impreza?
you cant does it click when you switch on ignition if not change it.
How do you replace the ignition in a 1993 Chevy Lumina?
IGNITION ? ARE we talking ignition coil-ignition wires ignition switch-key & tumbler.
How many quarts of oil are needed to do a oil change on a 1993 GMC Vandura 2500?
5 quarts
Do you have a wiring diagram for an electric window switch for a 1993 gmc vandura 2500?
Yes I do. would you like it faxed or e-mailed?
Where is the ignition switch located on 1993 Taurus?
On the right side of the steering wheel.
How do you replace a 1993 Corvette headlight dimmer switch?
How do I change the dimmer switch on my 1993 corvette?
How do you change an ignition switch on a 1993 Chevy S10 Blazer?
youve got to remove the steering wheel, take the locking mecanism off, then the mecanism for the signal lights off....whitch should only have a few screws.....then where the ignition switch is.....you should see a screw that looks like it goes through the switch..remove that then give the ignition switch a tug or two and it should come out
