Remove Horn Pad
Remove Triangular Circlip
Remove Steering Wheel Locknut (13/16ths - I believe)
Using Steering wheel Puller kit, Remove Steering Wheel
Once Steering Wheel is removed, Remove plastic insulator piece
You will now see steering wheel lockplate
Using lockplate removing tool, depress lockplate and remove c-clip from steering shaft
Lift off lockplate and lockplate spring
Remove Horn contact ring
Remove hazard switch button from outside of steering column
Remove turn signal stalk (if necessary)
You will now see the top of the turn-signal switch.
Remove turn signal switch (3 - #2 Phillips head screws)
Do not remove turn signal switch completely, just lay it out of the way
On right side you will now see a torx-head bolt (T-25 or T-30 I believe)
Remove Torx-head bolt
Slide ignition cylinder out.
Reverse procedure for installation.
The fuel pump is in the gas tank.
how do you replace3 dimmer switch 1987 chevy silverado 4 x 4
try to drill strate trough it than you should be able to turn it but dont drill to far
1987 save for a few carbed motors as options
To change the thermostat on a 1987 Chevy van, drain the radiator and locate the thermostat under the upper host assembly. Remove the bolts holding the thermostat in and replace it.
Late 1987 is when GM. changed fuel system to fuel injection.
rent a puller from auto zone!!! not hard at all!
you would need to change the differential gears to change the gear drive.
There is no easy way.
they didnt start making the beretta until 1987.
where is 1987 convertible switch for 1987 325i bmw
Its probably your timing chain or belt