It is very easy to change the license plate bulb in a 2001 Dodge Intrepid. You will need to remove the tag and then unscrew the light cover. After the cover is off, unscrew the light and replace with a new one.
If your license plate light is out change the bulb in it, if you have taillights your fuse is good as the license plate light uses the same fuse as the taillights.
If you kneel down and look up at the license plate, you should be able to see it. The bulb just pulls straight out of the socket.
Using a sharpie marker, hold the license plate up the the front bumper and mark the bolt holes on the bumper and then using a drill gently apply pressure and drill through the bumper, be sure there are no wires behind where you are drilling and not to drill in too far, then attach the license plate with two bolts and nuts.
Check the clutch plate or have it checked.
The vehicle identification number on a 2000 Dodge Intrepid motor is found etched into the block at the oil sump plate. This oil sump plate sits at a 45 degree angle to the block.
No, the tank has to be removed.
How do you change the lamp on the license plate of a lincoln ls 2000?
For the rear plate yes, but not the front one.
there should be screws that hold the clear lense on and i believe the bulb twist out
Probably
It is located on the throttle body, on the engine. It reads how far the throttle plate is opened.
how do you change the light bulb over the license plate on 2000 eclipse