answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2012-02-05 20:34:54
2012-02-05 20:34:54

It ain't easy. First pop the trim off around the unit, then if you have a radio above the temp unit take the radio out and then remove the temp unit trim to expose the bulbs. The bulbs twist out and you remove them from the rear. They are a specialty bulb only available from GM. Reassemble in reverse order above.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


the signal flasher is the hazard light switch......remove the radio bezel and change the switch


Hit the Hazard button it will be a triangled shaped button


The light switch in question is located on the back of the transmission towards the battery. You can change it yourself, just make sure you understand the wiring and if you need help ask.


On a 1999 Saturn vehicle, the backup light switch is located on top of the shift housing, which is situated on the top of the transmission. This switch requires a 7/8' wrench for removal.


On the centre of the ceiling (light for rear section)


The Chevrolet Colorado brake light switch is quite simple to change. The brake light switch simply plugs in and out.


Were and how do you change a brake light switch on a Daewoo Leganza 2001


The backup switch is on top of the transmission directly below the battery. @ wires to it



The only way to get the oil change light off of a 2007 Saturn sky is to change the oil in the car before the engine blows up.


On the turnsignal/light switch lever, on the same turn ring switch as rear fog light. If not you got change it to one with it.


It is quite simple to change the brake light switch on your 1998 Chevy S 10 pickup truck. The brake light switch simply plugs in and out.


In order to change the brake light switch in a Peugeot 307, you must dismantle and access the main light board on the dash and find the connecting switch, thusly flipping it back to the on position.


you might want to change your hazard light switch. i was having the same problem and i changed my hazard switch and it fixed the problem


Yes, you need to turn off the power when you change (replace) a light switch, since at least one of the terminals on the switch will always have power if the circuit is energized at the panel.


how to change reverse light in a 00 passat


On the undwerside of the dash attached to the brake pedal.


On top of the transmission, just under the battery.


Changing the brake light relay switch on your 1999 Chevy Cavalier is quite easy. The brake light switch simply plugs in and out.



To change the brake light switch on a 1999 Deville, remove the screws on the switch. It is located right on top of the brake pedal under the dash. It works as an open circuit.


See discuss question button below.


The signal light switch, on your Toyota Camry, can be changed by unplugging the signal relay switch. Plug in the new relay switch.


The force of gravity on the surface of the planet Saturn is the same as that on the surface of the Earth. Your weight would not change.




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.