0
What else can I help you with?
Where is the MAP sensor located on a 1998 Pontiac Grand Am?
i need a diagram of wher the map sensor is.
Where is 1998 dodge ram v8 mass air flow sensor or map sensor?
It doesn't have a MAF sensor, the Map sensor is on the front of the throttle body.
Where is the map sensor located on a 1998 Toyota RAV4?
The map sensor comes standard on a 1998 Toyota Rav4. It is typically located on the dashboard panel on the drivers side of the car.
Is there a MAP sensor in a 1998 Ford explorer?
I'm not a mechanic / technician but I checked www.motorcraft.com ( all 3 engines ) and it does not list a MAP sensor
Where is the MAF sensor on a 1998 Jeep Cherokee?
A 1998 Jeep Cherokee does not have a mass airflow sensor. It uses a manifold pressure sensor, MAP, which is on the rear of the intake manifold.
Does the MAP sensor do the same job as a MAF sensor on a 1998 dodge ram 5.2?
Basically, yes.
What is code P0108 for dodge gran caravan 1998?
Map sensor fault
Does your 1998 dodge ram have a mass air flow sensor?
No it uses a MAP (manifold pressure sensor) on the throttle body.
Does a 1998 dodge have an air flow sensor?
No MAF, it uses a MAP.No MAF, it uses a MAP.
Where is the Mass Air Flow Sensor located on the 1998 Honda Accord?
There is no mass air flow sensor on a 98 accord only a map sensor
Where is the MAP sensor located on a 1998 Ford Ranger 3.0 liter?
www. motorcraft. com ( no spaces ) does not list a MAP sensor for the 3.0 L in a 1998 Ford Ranger , there is an AIR MASS SENSOR listed which I assume is the same as a mass air flow sensor which would be located near your air filter housing
How do you fix a P0107 code on a 1998 Jeep Wrangler 4.0?
That is a MAP sensor code, check to see if the sensor is returning at least .5 volts, if not check for 5 volt reference voltage on the connector. If you have voltage going in, and none or less coming back out replace the sensor, if no reference voltage check the connectors, wiggle them and monitor the voltage. If the wiggle test checks out, draw a vacuum on the MAP sensor vacuum port. As you add vacuum the voltage should decrease. With no vacuum, the MAP sensor should read around 4.5 volts. If there is no change in MAP sensor reading on the scan tool, replace MAP sensor.
