It is against the law to change an odometer meter please
he mileage is stored in the computers on the van, and it is illegal to try to change the reading.
Yes, absolutely
It is the mileage that is actually on the car. If the odometer is replaced, the correct reading is written down. Add that to the reading of the replacment odometer and you have the actual mileage on the car.
It is the odometer in kilometers, the first is in miles.
It is possible, however against Federal law to do so
The exact mileage per year is the odometer reading at the end of the year minus the odometer reading at the beginning of the year. If you don't have the odometer reading from the beginning of the year, the next best thing is to subtract an older odometer reading from the reading at the beginning of the year, then divide the difference by the number of years between readings. Without any odometer readings from the past, the best you can do is to calculate the average annual mileage over the life of the truck, which is the current odometer reading divided by the truck's years of service.
By driving the vehicle
You can add engine wear but the reading on the odometer will not change since the sensor for the odometer is located at the output end of the transmission or transaxle, and therefore only gives a reading when the vehicle is moving (or when the wheels are spinning, if you are on ice or up on a hoist). So, no, you will not add mileage by idling.
this is a very easy procedure. it should at least be 5o degrees Fahrenheit in your car for that to happen
This question is not answerable.
There isn't a separate computer for just the odometer. Attached to the firewall behind the coolant bottle is the main computer. There are 3 cables that plug into the front of the computer and the odometer is in there. When you buy a new or refurbished computer for your jeep you need the vin number and the odometer reading so the computer can be programmed for your jeep. Meaning the odometer reading is in the main computer
With odometer reading selected (not trip A or B) turn key to LOCK and remove key (not sure if this is necessary) insert key, hold down odometer button while you turn key to ON position. Continue to hold down odometer button. Odometer display will show ------ then blank, your Maintenance Required light will turn off and your old odometer reading will return.