The oil on a 1995 Geo Prism is changed by placing a drain pan under the engine, removing the oil filter, unscrewing the drain plug, and allowing all the old oil to run out. A new filter is then installed, the drain plug put in, and the engine refilled with new oil.
it is right under the motor. it will be black with a bolt sticking out on the botom of it.
10w30.
First try snugging up the oil pan bolts but if that doesn't work you'll have to change the oil pan gasket.
I use 5w-30 in my 95.
what about it?
Most auto parts stores have information on capacities on their computers. I know O'Reilly's does. Just give them a call.
You'll need to drop the oil pan to replace the oil pump. There are only 2 or 3 bolts holding the oil pump once the pan is out of the way. The oil pan is the difficult part. The pump is easy. However... Oil pumps seldom fail. If you have low oil pressure it's usually because of excessive rod and/or main bearing wear. Change to a higher viscosity oil before you try to change the oil pump.
look in manual
It should be adjacent to the oil filter. It's below and to the left of the oil filter, under the alternator bracket.
Look under your exhaust manifold on the front of the engine. Towards the passenger side.
On the firewall, under your master cylinder. That is incorrect: The Oil Filter is located on the block; to the right and above the oil pan.
The type of oil that should be put into a 1995 Geo Metro is 5 W 30. The car uses approximately 5 quarts of oil.