0
How do you change the oil sending unit on a 5.0 mustang and what tools are needed?
Wiki User
∙ 10y ago
Its not difficult. Its located behind the Power Steering pump, and to the upper left of the oil filter. I will have a bronze anodized look to it and it shaped like a large acorn with one wire attached to it and the wire looks like a vacuum hose.
Most of the time you can remove them by hand but if not you will need a deep socket but I can't remember the size, maybe 3/4".
Disconnect the wire, pulls off, the remove by turning counter clockwise. Replace by reversing the same instructions. Do not over tighten, hand tightening is enough.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What tools are needed for oil change?
The tools needed for an oil change tend to be common tools. A floor jack is needed to access the oil pan. A pan which is used to drain oil into. A wrench and socket set is used to remove and replace the oil cap.
Where do you get the tools needed to change radio in 2006 dodge sprinter?
Dealer
Do you need any special tools to change the front brakes of a 2000 Silverado Z71?
No special tools needed.
Are there special tools required to change the fuel pump in a 99 montaro sport?
No, no special tools needed, just common hand tools.
What tools are needed to change the rear brake pads on a 2002 Impala?
basic tools are all that are needed its a simple job. They are disc type brakes.If you can do the front, then you can do the rear.
How do you change front brake pads on a 1996 Ford Taurus?
what tools are needed
What tools are needed to change the pads on a 1994 Eclipse?
socket rench and a c-clamp
What tools are needed to change rear drive-shaft on 04 f350?
Impact and wrenches
Time needed to change cap and rotor on1993 corvette?
about 30 min if you have tools available
What tools are needed to change brake pads on a 1998 Chevy Monte Carlo?
ratchet or socket
How long does it take to change the engine on a 1994 camaro?
About 7 hours with all the tools and experience needed
Tools needed to change fuel filter on 1997 Ford Crown Victoria?
A flat head screwdriver.
