you will need....bearing kit (includes seal) ,, approx
with wrenches.
Begin by removing the tire and wheel from your 1993 Nissan. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install your new rear wheel bearing.
Remove the wheel from your 1993 Mercury Cougar. Loosen and remove the wheel bearing nuts. Remove the wheel seal and the wheel bearing. Reverse the process to install your new wheel bearing.
if you have to ask how to do this job, then it is beyond your ability. that bearing is pressed on the axle........
The wheel bearing?
YES....
No, the front hubs are sealed units on a Grand Cherokee.
15 x 6 for a 1993. 1997 on has 15 x 7
Break shoes or pads worn out, or a defective wheel bearing. Have this repaired ASAP.Break shoes or pads worn out, or a defective wheel bearing. Have this repaired ASAP.
If, after close inspection you do not see any damage to hub, you can use it. But ALWAYS install new bearing race with bearing.
You have a wheel out of alignment. You have a wheel out of balance. You may have other problems such as a bad wheel bearing. Your wheel could be about to fall off.
http://autozone.com/home.htm