Chevy Cavalier

How do you change the serpentine belt on a 1996 Chevrolet Cavalier?

678

Top Answer
User Avatar
Wiki User
2009-06-13 07:56:16
2009-06-13 07:56:16

Note:The drivebelt routing decal on the radiator shroud to help during drivebelt install * To replace the belt rotate the tensioner pulley clockwise to release belt tension * Remove the belt from the auxiliary components and slowly release the tensioner * Route the new belt over the various pulleys again rotating the tensioner to allow the belt to be installed then release the belt tensioner

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

1996 Chevrolet cavalier shuts off while driving and have to put in natural or park to restart

User Avatar

there should be a sticker on the underside of the hood on the passenger side of the car

User Avatar

open the hood and look up, it will be right in front of you. If that does not work, you can buy a haynes or chiltons manual.

User Avatar

Providing your cavalier has a 2.2l, this is what your looking at.

User Avatar

If a 1996 Chevrolet Cavalier will not start, it could very well be the fuel pump. It could also be the starter or battery.

User Avatar

how do you chance a serpentine belt on a 1996 ford escort

User Avatar

Both the 2.2 and 2.4 liter four cylinder engines in a 1996 Chevrolet Cavalier use a timing CHAIN

User Avatar

The oil pressure switch on a 1996 Chevrolet Cavalier is on the rear of the engine block. It will be directly above the oil pan.

User Avatar

The coil pack, on a 1996 Chevrolet Cavalier, is located on the top of the engine. The coil pack is near the electronic spark distributor.

User Avatar

Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier

User Avatar

Yes, there is no reason you should not be able to change the oil by yourself in a 1996 Chevrolet S10.

User Avatar

Chevrolet does not use inertia/reset switches.

User Avatar

Chevrolet does not use inertia/reset switches.

User Avatar

You can find an exhaust bracket for a 1996 Chervrolet Cavalier in Billings, Montana at your local Auto Yard. You can find great deals!

User Avatar

It should be above where the passenger places their feet. Facing the firewall.

User Avatar

The 1996 Chevrolet Cavalier headlight module can be found on the firewall, in the engine compartment. The module will be on the drivers side of the firewall.

User Avatar

The drivebelt routing decal on the radiator shroud to help during drivebelt install

User Avatar

The 1996 Chevrolet Cavalier resistor pack fan control switch is located on the back of the fan motor. The fan motor is located directly behind the fan.

User Avatar

Your 1996 Chevrolet Cavalier 2.2 liter engine oil pressure should be approximately 40 psi. A range of 35 to 45 psi is acceptable.

User Avatar

It should fit if both cars had that engine from the factory. If the 1996 was a Z24 (2.4L), then there will be differences - most likely with engine electronics. Hope this helps!

User Avatar

the clutch is self adjusting you check the fluid level just refer to the manuel


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.