Diconnect the wires on the top, attached to two small bolts. Remove the two bolts holding the starter on from underneath, be careful not to let it drop on you. hopefully your headers and transmission lines arn't in the way.
A person an change the starter on a 2002 GMC Sierra 1500 by disconnecting the battery and removing the retaining bolts on the starter. The original starter is then disconnected from the wiring and a new starter reconnected.
The starter on a 2002 Sierra 1500 5.3L is changed by disconnecting the negative battery cable and unbolting the starter. The starter is then lowered, the wires disconnected, and a new unit put in its place.
Check the alternator if that don't do it change the battery
You will need to take out the parts of the ignition and put in new parts. It is usually best to trust a mechanic to do this for you.
The starter of the 1994 GMC Sierra 1500 pickup is located on the dashboard. It is usually attached by a small wire.
84-88
no
Starter solenoid? One top of starter--follow + battery cable
Follow the positive battery cable (the big one); the starter will be at the end of it.
You put it where it belongs
the starter should be on the right side of the engine block there aretwo or three bolts going into the block then the starter should come down a little but on the front of the starter there is a nut holding on wires to the starter i think they are 10mm. once the bolts are out of the block and no wires are on the front of the starter it should come out. its a 10 minute job if that
That would be inside the polar control unit