Press brake pedal down to the fully applied position. Rotate switch about 30 degrees in a counterclockwise rotation then pull rearward and out of bracket. To install pull plunger out fully. Press brake pedal down fully. Insert switch into mounting bracket and align the locator tab on switch with the notch on the bracket. Rotate the switch clockwise about 30 degrees. Release the break pedal then pull forward to adjust switch. You will hear a clicking sound while it is adjusted.
Your Answer
Related Questions
You have 2004 Jeep Grand Cherokee Laredo brake and abs light is on how can you fix it?
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
Change radiator on 95 Jeep grand Laredo?
how to change radiator 1995 jeep grand Cherokee Laredo
How do you change a stop light bulb in a 2002 Jeep Liberty?
See the amswer for "How do you change the rear stop light bulb on a 2002 Jeep Liberty passenger side". It works.
What ac Type of Freon to use jeep 2002 grand Cherokee Laredo?
A 2002 Jeep uses R134a.
Is the 2002 Jeep Grand Cherokee Laredo with an inline 6 a good jeep?
Yes.
What does perform service light mean in a 2004 Jeep Grand Cherokee Laredo?
it means its time for on oil change
How do you replace a brake light on a 2002 Jeep Cherokee Laredo?
Open the Hatch door you will find two philipps screws next othe edge of the light after unscrewing these pull out the entire tail light this is on a ball hinge just pull stright out and change light.
How do you change cabin filter jeep Laredo 2004?
A 2004 Jeep does not have a cabin filter.
Do 2002 Jeeps have the latch system?
I have a 2002 Jeep Grand Cherokee Laredo...It does NOT have a latch system.
What does the yellow operation malfunction light indicate on a Jeep Grand Cherokee Laredo 2002?
The computer has detected a malfunction and set a trouble code.
How is the 2002 Jeep Grand Cherokee Laredo rated?
http://www.partsamerica.com/ReliabilityRatings.aspx
Were is fuel pressure regulator in 2002 jeep grand Laredo?
On the pump in the tank.
Does a 2002 jeep laredo have a safety cut off switch on the fuel pump?
No.No.
What type of freon is used in a 2002 jeep grand Cherokee Laredo?
The type of Freon used for your 2002 Jeep Cherokee Laredo is R-134a. This can be found at your local mechanics or usually at a local auto parts store.
How do you change ignition switch on Jeep Cherokee Laredo?
necesito ignition switch on jeep Cherokee Laredo 1996 mi correo es skyrouse@hotmail.com
Do you have a diagram for the fuel filter of a 2002 Jeep Grand Cherokee Laredo?
Its mounted to the frame
What type of transmission fluid in in a 2002 jeep Cherokee Laredo?
Mopar ATF+4
What can cause the 2001 Jeep Laredo back light to malfunction?
The Jeep Laredo back light would malfunction would malfunction in much the same way any back light would, primarily due to cross-wire, or an internal error.
Will a 97 jeep Laredo transmission fit a 95 jeep Laredo transmission?
No.
What is the little light that looks like on engine or something mean on 2002 jeep grand Cherokee Laredo?
Check engine light. It means there is a problem with the emissions system. Take it to the dealer for repair.
How do you change the dash lights on a Jeep Grand Cherokee Laredo?
i have jeep grand cheroke 2008 since the check engine light is on and i don't have any problem when i drive the car but how i reset this light (chek engine ligt on) with thank's
What size battery for a 2002 Jeep Grand Cherokee Laredo?
A 2002 Jeep Grand Cherokee uses a group 65 battery with 750 cold cranking amps.
How do you change the cabin air filter on a 1998 Jeep grand Cherokee Laredo.?
A 1998 Jeep does not have a cabin filter.
Is a Jeep Cherokee and Jeep Cherokee Laredo similar?
Yes, Laredo is just a trim package.
What type of oil is used in an oil change for 1996 Jeep Cherokee Laredo?
10w30
