answersLogoWhite

0

Open the tail gate and look at were the straps that hold the tail gate are at on the sides of the bed. Now look at the 2 Phillips screws and remove them then the light will come out.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you change a fuel pump in a 1988 Chevy 1500 truck?

It's on the side of the motor


Will the engine from a 1994 Chevy 1500 interchange with a 1988 Chevy 1500?

If the cubic inch is the same the motors should swap out ok. You will have to change some parts but most Chevy motors will swap.


Will a rear end from a 1984 Chevy 1500 fit in a 1988 GMC jimmy 1500?

Yes. A rear end from a 1984 Chevy 1500 can fit in a 1988 GMC Jimmy 1500.


How many qts of oil at change on 1988 Chevy silverado 1500 5.7 v8?

5 quarts


Will a 2000 Chevy 1500 dash fit in a 1988 Chevy 1500?

No way, Not even close.


Is the rear window on a 92 Chevy excab 1500 enterchangeable with the 88 regular cab?

In 1988 there was a body style change , if the 1988 is the new body style then Yes you can.


How do you take a bed off a 1988 Chevy 1500 pick up truck?

remove the bed bolts and disconnect the wiring harness behind the bumper for the tail lights


What is the towing capacity of 1988 Chevy 1500?

10,400 lb


Where is the Oil Pressure Sensor on a 1988 Chevy 1500 5.7?

The oil pressure sensor on a 1988 Chevy 1500 5.7 is located on the engine. It is on the right side, near the intake manifold.


Will a 4 speed transmission from a 1988 Chevy 1500 2 wheel drive interchange with a 4 speed transmission from a 1988 Chevy 1500 4 wheel drive?

No, the rear section is different.


How do you change the ignition switch in a 1988 Chevy Camaro?

How do i change the ignition switch in a 1988 Chevy camaro


Do you have a wiring diagram for 1988 Chevy 1500 series for tailights?

try www.haynes.com