Well it depends on the type of engine you have, but that only has to do with the thermostat's location. The Haynes GM manual #38025 has instructions on how to change the thermostat in section 3-3. Amazon has copies of it dirt cheap.
The Thermostat is located in the neck where the upper radiator hose connects to the engine. you have to take off the upper intake plenum to access this. Alot of crap just to change the thermostat. excellent design GM. Jamie
At the engine end of the top radaitor hose, under the thermostat housing.
Wild guess: On most GM vehicles it's under the hood, on the firewall, on the passenger side.
NO, It is different.
how do you change serpentine belt gm 3.4 2003 venture
Take it to a garage it's a big job cost me $300. to get it done have to tear half the motor apart. Idiot GM does it on purpose! Murray
No, Gm does not use inertia switches.No, Gm does not use inertia switches.
On the dashboard
192 - 195 degree
Follow the top radiator hose back to the engine. The radiator hose connects to a housing that is bolted to the intake manifold. Remove the radiator hose the remove the two bolts that hold down the housing and the thermostat is right there.
Divide (gm) by 1,000 to get the same mass in (kg).
The 1900s goes from 1900 to 1999. GM was founded in 1908. The answer will be millions.
the average gas mileage for 1991 GMCSafari XL van?
Change the coolant temperature sensor. Trust me, I own an Express and had problems starting when it was cool and humid. A $10 part, located in the thermostat housing on the top front half of the engine. Very easy to fix, but a huge pain in the backside problem to diagnose. You can thank me later because I know how frustrating this problem is.
All Chevy transmissions will bolt up to the 350 small block and big blocks from 1999 down. They are all the same. GM. did not change until late 1999.
Use the process of elimination.
The GM Safari was produced from the years 1985 to 2005. The vacuum switches for the AC vents on a 1995 GM Safari all-wheel-drive van are located underneath the dashboard.
Gm does not use inertia switches.
There is no reset button on the thermometer in a rear view mirror on a 1999 GM Yukon. However, you can try to reset it by disconnecting for five minutes.
3.1L? read the instructions under how to change on a 1996 cutlass...its the same motor and in the same place and is changed the same way. that's the nice thing about GM. .