2002 Mazda Miata MX5 center high mount stop (third 3rd brake light) light bulb lamp replacement: Purchase the correct replacement center high mount stop (third 3rd brake light) bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the center high mount stop (third 3rd brake light) bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. If there are multiple bulbs, you may want to consider replacing all at the same time in order to keep brightness and color equal (optional).
with a hammer
How do I adjust a stoplight switch on my mazda 626 LX V6
If you want to change the brake light, you will need a Torx screwdriver. You will also have to open your trunk and remove the lens cover assembly.
Yes unfortunatly
I think the light assembly screws out from the inside of the trunk.
remove the 4 10mm nuts under the plastic cover in the truck. the complete light assembly will then come off the car. then just twist socket to remove the bulb
The way that you change a high mount brake light on a 2007 Taurus is by first prying the light assembly from the housing. You then push rearward to remove it from the retaining clips. Next, life the light assembly from the shelf and disconnect the assembly wiring. Replace the light assembly and reverse directions to put the light housing back where it goes.
From inside the trunk.
To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.
There are three black caps that screw off in the trunk behind the brake light itself unscrew them and the assembly comes out then change bulb
You must remove the entire light assembly as follows: Lower the tail gate and remove the two small screws that screw into the side of the assembly. Next remove the two screws on the outside of the assembly that are accessible through long holes on the outside of the assembly. Pull the assembly back to expose the rear where the lights are located.
brake lights dont work