Depends on whether you have coil springs or torsion bars.
how do i change a lower ball joint on a 1992 ranger 2wd
You change the control arms, upper and lower. The ball joints are manufactured into the control arms.
How to change upper and lower ball joints on a 1997 ford explorer all wheel drive?
What year, if it has upper it has to be pre 1989
It depends on the year, and whether it's 2WD or 4WD. I suggest entering your question again with the year. People have posted answers for specific year models. All Ford Rangers from 1993 to 1997 have "I-beam" front suspensions as opposed to the upper and lower control arms that most vehicles have. There is a detailed answer for replacing the upper and lower ball joints for '93 through '97 Ford Ranger ball joints at the question: "How do you change ball joints on 199X Ford Rangers?"
To replace ball joints on a 2004 2WD Ranger, lift the upper control arm of the spindle assembly and remove the nut holding the lower ball joint in place. Then lower the lower control arm to relieve the ball joints. Replace with new.Ê
The lower ball joints have to be pressed out. The upper ball joints are part of the control arm, so the complete upper assembly has to be replaced.
Change lower ball joints on a 96 gmC 4 by 4
Disconnect the upper and lower joints, put the ring of the lyre on the lower joint, tighten the lyre, reconnect the upper and lower joints.
I believe on the 4 x 4 , with the torsion bar suspension , the upper ball joints are part of the control arm and the lower ball joints can be replaced separately or with a new control arm The 2 wheel drive , with the coil spring front suspension , the upper and lower ball joints can be replaced separately
The ball joints are riveted or pressed into the upper and lower control arms, then the spindle is bolted to the ball joints.
I changed mine . I purchased the parts at Auto Zone.
I think you met joints, and the joints are the upper joint and the lower joint. The order of clarinet peices from the top is mouthpiece, barrel, upper joint, lower joint, bell.
The upper ball joints must be replaced with the upper control arms but the lower ball joints can be replaced seperately. NOTE: THE BEST WAY TO GET THEM OUT IS TO KNOCK THEM OUT WITH A 3LB MINI SLEDGE HAMMER FROM AUTOZONE. According to my Haynes repair manual it states that 1995 and newer models upper and lower balljoints are not removable or serviceable. If a balljoint is damaged or worn, replace the control arm.
Go to fordtruckenthusiasts.com and post your question.They have a forum for your vehicle and you will get a quick and accurate reply.Good luck.
you dont they dont have grease zerks you have wait until they go out and then replace them with after market parts that have a place to install a zerk
Change upper and lower ball joints the factory ball joints have no fitting for lube. The aftermarket one do
which ones? upper or lower?
There are no upper ball joints - that role is played by the McPherson struts. See "Related Questions" below for more
Basically, 2 pieces of metal with a rubber boot in the middle that should be squishy (grease inside it) with zerk fittings on the ends.
The answer to this Question is that there are 46 or 45 joints in the human body. x3
There are many joints present in the body. Some are ball and socket joint, joint between the upper jaw and the lower jaw, joint between the upper jaw and the head, joints in the skull, joints in the fingers, joints between the toes, joint in the wrist,etc.
The lyre is inserted between the upper and lower joints - the middle of the instrument.