the compressor is not running. Check your breakers.
serial number of amana ptac
Wha parts are you looking for?
With an ohm-meter. Check for continuity in the RUN and START windings, and also from the terminals to compressor case for shorting. There should be continuity in the windings and no continuity from windings to compressor case.
Low pressure relay is bad! Check freon pressure, if it falls too low, the compressor will not run (installed for safet of compressor)
Is it a central unit? check and see if the fan and compressor are running in the outdoor unit. The system may be low on freon or the compressor may not be running. It is best to call a qualified HVAC technician.
Up to 2 forced air units to one compressor unit.
Remove and contain the refrigerant; if you suspect the compressor motor has a burnd-out; treat the refrigerant as contaminated. Disconnect the lines from the compressor, including electrical, replace the filter, and compressor, purge the system, check for leaks, vent the nitrogen, do a pull down below 500 microns, replace refrigerant, and oil. do a run up check pressures, and temp.
You cannot return the compressor unless it is the reason your system is not working. No need to reuse the compressor as you will have a brand new unit anyway.
Does it have the correct amount of refrigerant, are the compressor valves good, is the indoor coil plugged.
There isn't a need to check the oil in the compressor. Oil is suspended in the refrigerant to keep the internal parts of the unit lubricated. If you're seeing oil on the lines or coil of the unit, you may have a leak. Be sure to get it checked before it does serious damage to the unit.
It could be that the unit is overcharged and the compressor is shutting down on overload. Check to see if the compressor is running when the hot air starts blowing.