0
How do you check for vacuum leaks in a Chrysler PT Cruiser?
ChixthatFix
If you are talking about induction leaks causing poor running and an uneven tick over a handy way to hone in on the location is to spray lightly around induction areas such as inlet manifold where it joins the head with a WD40 aerosol, as this is flammable if you locate the leak your idle speed will increase.
Also there are quite a lot of breather hoses small and large in the same area which are prone to cracking and if you locate one of these your WD40 will have the same result.
Good luck.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you check a vacuum hose for leaks on a dodge 3500 diesel?
How to check for leaks on vacuum hoses for a dodge diesel
Where does water coolant leak under motor from on a Chrysler PT Cruiser?
It leaks from the failed part.
How do you put oil in gear box of a PT Cruiser?
To put oil in a gear box of a Chrysler PT Cruiser, first plug minor coolant leaks.
Chevy 350 stalls?
check for vacuum leaks
How do you adjust the idle speed on a 1998 Chrysler cirrus?
Idle speed on a 1998 Chrysler is computer controlled and is not adjustable. If idle speed is incorrect, you have a sensor, actuator, or mechanical failure. Places to start are, check for engine fault codes. Check for vacuum leaks.
360 engine backfires under load?
check your timing and vacuum advance and vacuum leaks. from there check fuel delivery system.
Recharge air condtioner on 1999 Chrysler Concorde?
Proper method is: Vacuum system and wait 15 minutes to see if vacuum is held (to check for leaks) add proper type and amount of compressor oil add proper amount of 134a
Engine running lean 95 Chevy blazer?
Check for vacuum leaks.
Why is my Chevy 350 sputtering?
allot of reasons check the carb. check for vacuum leaks. check the timing. check the comp codes.
How do fix the heistation on a 1994 Honda Civic?
check for vacuum leaks, broken hoses and hisses.
Why would your 86 vanagon be running perfectly but revving very hi?
check for vacuum leaks
99 ranger XLt sometimes 4x4 will engage sometimes it wont?
check the vacuum diaphragm for leaks. Might be a hole in the vacuum line.
