It should have eithert a view port or a dip stick style level indicator on hydraulic reservoir
Dipstick
11.1 gallons (44.4 quarts)
Take the soft cover off, the drive shaft out and put the seal back in. Then install the fix kit from kubota. Its a common problem.
how do i check my hydraulic fluid on my tipper ram on my nissan cabstar
if the foot pedal is operated with the tractor off, the hydraulic fluid can leak back out of the power steering pump. work the wheel back and forth for a minute or two to get fluid back into the steering box. also, check the hydraulic fluid level.AnswerThere is a brass connector between the hydraulic pump and the PS pump. This connector may have broken. or the end of shaft may have broken. This was the case with my L2250 DT
Right next to where to PTO shaft comes out of the back of the tractor there is a sight glass for the hydraulic fluid.
A list of Preventive Maintenance Task for a Hydraulic System could be: Change the (could be the return or pressure filter) hydraulic filter. Obtain a hydraulic fluid sample. Filter hydraulic fluid. Check hydraulic actuators. Clean the inside of a hydraulic reservoir. Clean the outside of a hydraulic reservoir.
There is a small round window on the transmission that can be seen just behind the clutch pedal on the left side of the tractor. The hydraulic fluid must be filled so the oil level is between the two lines etched on the window. It takes about 8 gallons of hydraulic fluid for a drain and fill. The fill hole is under the rubber plug on the raised portion of the seat area between the driver's knees. There are four drain plugs.
plug in side of tran or dipsteck
Check the hydraulic fluid. Hydraulic cylinder piston rubber washers to replace.
One-way valve is used for the hydraulic fluid does not return.
J