0
You don't - throw it away. Is it worth risking a thousand dollar motor for a five dollar filter ?
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you change oil filter Pontiac g6 2008?
To change the filter you'll need a good adjustable wrench that stretches to about 31-32". Unscrew the oil cap on top of the engine and remove the "ECOTECH" cover for the engine. (just unsnap it) Look to the driverside and you'll see a black cap with a big 31-32" hex on it that says 25nM. (dont know what this means? Unscrew the cap counter-clockwise and it will expose the small air filter looking oil filter. Throw the new one in and put everything back like you found it!
How many quarts of oil fill the 2002 Hyundai sonata 4 cylinder?
The owners manual for a 2002 Hyundai Sonata says that you need 4.4 quarts of oil. The oil pan capacity is 4.2 quarts and the oil filter itself holds .31 quarts.
When was Syphon Filter created?
Syphon Filter was created on 1999-01-31.
What are the fluid capacities for 1993 Chevrolet lumina with a 31 engine?
oil w/ filter 4.5qts tranny (automatic) 7qts gas 20 gal coolant 12.4qts
How is the oil filter housing removed on a 1993 Toyota Camry How long the short threaded pipe which filter screws onto.?
The oil filter housing is also the oil cooler on a 2.2 liter 4 cyl. The question does not state the reason for removal, but I might assume that there may be an oil leak behind the filter. First, unscrew the oil filter. Behind the filter there is a threaded pipe that the filter screws onto. At the base of this short pipe there should be a 30 or 31 mm nut. The pipe and nut are one piece. If you don't have access to an impact, get a long extension and a breaker bar. Have someone help steady the extension as the nut will most likely be very tight. Try not to round off the corners of the nut. After removing the nut there will be a barrell behind the nut with a spring inside. This appears to be a check valve to release the oil back to the engine when stopped. There is a small O ring seal at the base of this piece. There is also a large O ring seal on the mating surface of this housing. The large seal on my engine was very brittle and leaking down the block. Both seals will run about seven dollars and change. If you are careful you should be able to replace the seals and clean both surfaces without removal of the hoses going to the cooler. This was a cheap and easy fix for a smelly burnt oil leak problem.
When was Oil on Ice created?
Oil on Ice was created on 2004-05-31.
What is Cosmo Oil Company's population?
The population of Cosmo Oil Company is 31.
Why will a 1998 31 Malibu startup but then slowly die Could the problem be the oil pump And how do you chage the oil pump?
No, more than likely it is the fuel system. If it was the oil pump the sensor will not let the engine turn over. Your problem is more than likely your fuel filter is clogged up. Or your fuel pump is weak and going out.
What are the release dates for The Merry Motor Menders - 1916?
The Merry Motor Menders - 1916 was released on: USA: 31 October 1916
Can you use 2.5sqmm wire for a 7.5 kw motor?
No you can not it's 31 amps
What are the release dates for Clean Freaks - 2012 TV?
Clean Freaks - 2012 TV was released on: USA: 31 March 2012
What are the release dates for The Great Clean Up - 1920?
The Great Clean Up - 1920 was released on: USA: 31 October 1920
