Soak a towel in hot water and then squeeze most of the water out - especially if the drawer is made of wood. Lay the towel flat along the melted candy. It should melt slightly, and you may have to do it a couple of times.
You should use very warm water and some steel wool on the fabric, that will release the candy from the fibers, getting it completely clean. Hope this helps.
#
Say There Get Extra Candy.
you wash it then drie it
What happened when nitrogen gas pass though from melted copper at 1250 Centigrade temperature. when i melted the scrap copper in furnace there is some impurity how i can clean and get the piurty of copper 99.99 %
You shove everything into the closet, into a drawer, under the bed, under the bed covers, on the front lawn, etc.
go to walmart and buy specal wipes
It means I take you to the hotel. Clean version.
Clean and tinned with melted solder
this recipe isn't mine but it's great, fun and delicious. THese are chocolate candy heartsWhat you'll need:Plastic heart-shaped candy moldRed, white and cocoa colored candy meltsSandwich bags (zipper, not pleated)ScissorsSpoonWax paperPlateWooden skewer or clean craft paint brushHow to make it:Put a handful of candy melts into an open zipper sandwich bag.Microwave candy in bag for 30-40 seconds or until melted.Cut one corner of the bag with scissors to squeeze melted candy through. Caution: Bag may be hot, so use paper towel or a pot holder to handle it.Gently squeeze chocolate out of bag and into the molds.Tap the side of the mold tray to knock out any air bubbles and flatten chocolate.Place in refrigerator until set.Pop out of molds and serve.DecoratingPolka dots - Use the flat end of a wooden skewer or a clean craft paint brush to dip into melted chocolate. Dot onto molds, then refrigerate. Remove mold from refrigerator when solid, then add contrasting color according to directions above.Drizzles - Use a spoon to drizzle melted chocolate across the molds by sweeping a spoon back and forth and allowing chocolate to fall in streams. Refrigerate until solid. Add contrasting color according to directions above.3D Drizzles - Use the spoon method above, however this time drizzle the chocolate over solid candy that you have already made and let set, rather than drizzling into the molds.
Ammonia is not a cleaner we'd choose to remove plastic from surfaces. It (ammonia) won't dissolve or "melt" the plastic, so it is ineffective in removing melted plastic from surfaces.
The disadvantages of taking a bath in melted chocolate is that the chocolate might be difficult to wash up your body and clean the tub, it is quite expensive and time consuming to melt all that chocolate.