hold down the reset button as you turn the ingniton key on. continue to hold the button until the light resets to a new 10kmile cycle. you don't need to start the vehicle just turn key to aux positon while you push the reset button for your odometer in
Probably a problem with emission system - have vehicle scanned at auto part store to determine problem or clear codes
Sorry, your question is not very clear; not sure what you need?
It needs maintenance you can disconnect the negative (-) terminal of the battery and reconnect it to clear any erros in the ECU
To clear the maintenance light; steps to take: With the ignition off, press the trip and reset buttons at the same time and hold, turn ignition on, hold for about ten seconds until it goes out. Dilemma solved.
To turn off the maintenance due reminder on a 2017 Honda Accord with the Honda Sensing package, start the vehicle and ensure it is in the "On" position without starting the engine. Press the "Home" button on the infotainment system, navigate to "Settings," then select "Vehicle." Choose "Maintenance Info" and then select "Reset" to clear the maintenance reminder. Finally, confirm the reset action, and the reminder should be turned off.
To clear the maintenance required light on a 2005 Lexus RX330, turn the ignition to the "ON" position without starting the engine. Press the trip meter reset button on the dashboard until the trip meter displays "0." While still holding the button, turn the ignition off and then back to "ON." Release the button, and the maintenance light should reset.
You get what ever is causing it to be illuminated repaired and then clear the associated codes
With an automobile diagnostic computer, the mechanic will clear it for you, but it will cost you. Not much though.
It is in the fuel pump housing. Add a basic "clear" in line filter for two stage filtration and much simpler routine maintenance.
To clear the maintenance required code on a 2005 Acura MDX, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. This action should reset the maintenance light. Finally, turn off the ignition, then start the engine to confirm that the maintenance light has been cleared.
Codes A12 means you need to Change the Oil/Filter, Rotate the tires, and Replace the air & cabin filter. You clear the code this way.1. Insert the key into the ignition. Turn the ignition switch to the "II" position.2. Press and release the "select/reset" button on the information display until the maintenance message displays.3. Push and hold down the "select/reset" button for approximately 10 seconds until the maintenance-required light starts to blink on and off.4. Push and hold the "select/reset" button for about five more seconds until the maintenance light resets.
Yes, clear bags are required for carrying travel liquids.