answersLogoWhite

0

rear brake pistons are called actuated pistons. And the twist in and out. You will need a special tool to twist them back into the caliper. Unlike the Front Pistons which can be pushed back.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you replace the rear calipers on a Volvo 240?

2 Bolts on the back. Remove them and remove the Brake line, and Install new doing the inverse


Where is the fuel filter in front or rear on a 1990 Nissan 240 sx?

In the gas tank itself


If you wanted to make your 96 Nissan 240 standard can i swap it with a 93 Nissan 240 transmission?

Yes, Nissan used the same transmission for all of the rear drive ka24s, single cam and dual cam. Even the trucks have the same transmission.


Can a Nissan 350 engine fit in a Nissan 240?

Yes.


Will a 1995 Nissan 240 engine it in a 1990 Nissan 240?

There is no problem with the fit. The computer has a different conector but can be made to work.


What is the cost of a tune up for a 2007 Nissan Murano 240?

The cost of a tune up for a 2007 Nissan Murano 240 is $15000.


Does a 1988 Volvo 240 dl have anti lock braking?

No. The Volvo 240 Series of cars did not receive Anti-Lock Braking until 1991. It does, however, have a four wheel disc brake setup with four calipers per rotor on the front axle, and two calipers per rotor on the rear with a triangulated braking circuit, as opposed to a conventional split braking circuit, which happens be found in the ABS equipped models.


What is 2002 Nissan Altima's horsepower?

about 240 hp


What is the spark plug gap for a 1991 Nissan 240sx?

My 1992 Nissan 240 sx is 038


Will a 1989 instrument cluster work in a 1993 Nissan 240 sx?

A 1989 instrument cluster will not work in a 1993 Nissan 240 SX. You will need a 1990 to 1994Êinstrument cluster.


What is the firing order on the 1989 Nissan 240 sx?

1342


Where is the fuel pump located on the 1991 Nissan 240?

remove rear compartment floor trim remove greenish colored cover screws remove cover remove screws from pump assy and lift out.