0
wireless head sets have battery's around 3 to 9 volts one of two ways you can do this A replace the battery with recharge type and 12v charger or B remove the battery's fit a socket or hard wire a cable from a simple power supply made from a lm317 or lm338k voltage regulator from any good electronics store time to make it 15 minuets cost $5 lots of data on this chip LM317 on the net easy easy to use it has 3 pins, in, adjust, out, all you need is 2 caps 2 diodes 2 resistors.
What else can I help you with?
Do you need a special wire for the xbox 360 stereo headset?
the headset does not connect to the console, but in a round hole on the controller. if there is no wire to plug in, it is a wireless
Something to make a headset wireless I have a Razer electra headset and it has a detachable wire I need something to make it wireless with a microphone preferably?
you need to get an extra wire to connect with the razer electra with a microphone circuit
Do you need a wire to talk through a wireless headset?
NO
What wire do I connect the 277 VAC wire to?
It depends on what 277 volt device you are trying to connect.
What wire is used to charge geotech-ex-01 wireless bluetooth headset?
the wire to charge ur controlor ( hope it helps)
How do you wire a 12 volt heater motor in place of 2 wire 6 volt heater motor?
To wire a 12-volt heater motor in place of a 2-wire 6-volt heater motor, first ensure that your power source can supply 12 volts. Connect the positive wire from the 12-volt heater motor to the positive terminal of the power supply, and connect the negative wire to the negative terminal. Make sure to use appropriate fuses or circuit breakers to protect the system from overcurrent. Lastly, confirm that the motor's specifications are compatible with your application to avoid damage.
If you don't have Internet on the dsi can you get it for free?
Yes, just connect it to your wireless internet if you dont have wireless internet then go to some other place and get it and you dont need to get a wire to connect it.
How do you wire a 230 volt contactor with a 110 volt coil?
To wire a 230 volt contactor with a 110 volt coil, you need to connect the 110 volt power supply to one terminal of the coil and the neutral wire to the other terminal of the coil. Ensure that the contactor is rated for use with a 110 volt control circuit. Additionally, verify the wiring diagram provided with the contactor for proper connection details.
How do you charge 6 volt batteries with a 12 volt charger?
If you have two 6 volt batteries you can take a jumper wire and connect the negative post on one battery to the positive post on the other battery then connect the remaining pos and neg posts to the 12 volt battery charger.
How do you wire a 3 wire 240 volt stove to a 240 volt 4 wire feed?
Change the cord/plug on the stove to a four wire cord/plug. When installing the new plug remove the grounding strip that connects the center lug in the stove wiring block to the frame of the stove. Connect the white wire from the new plug to the center lug. Connect the green wire from the plug to the stove frame.
Is a 300 volt wire good to connect a range?
The 300 volt insulation rating on wire is the maximum amount of voltage that can be applied to that wire. If your range falls within that range then it is safe to use. Some commercial ranges use 480 and 575 volts. For theses types of ranges the 300 volt wire will not do, it will have to be wire with a conductor whose insulation rating is 600 volts or greater.
Does the ground wire from a 240 volt tankless water heater connect to the common wire?
Any ground wire has to be connected to an independent ground wire that returns directly to the distribution panel and not to the neutral of the circuit.
