if you conect the signal wire to one of the cylanders it will sence the movement and your tacho will work for a brief time until your motor screws up which is an improvement on your gay $1000 EB on gas
Get a Mechanic
To wire a rev counter (tachometer) to the ECU of a Ford Fiesta MK3, locate the ECU connector and identify the signal wire for the engine RPM, typically colored green or yellow. Connect the rev counter's signal input to this wire. Ensure that the rev counter is properly powered and grounded. It's also a good idea to consult the specific wiring diagram for your vehicle model to confirm the correct connections.
5800 rpm's
Thermostat is gone, change it
My truck flutter and temperture gauge drop at the same time
Where is the ford ranger 2004 revcounter sensor conected
Its 4K RPM's.
You have a vacuum leak at the intake.
To repair the gas gauge on a 2003 Ski-Doo Rev, first check the electrical connections and wiring for any damage or corrosion, as this can affect gauge functionality. If the connections are intact, inspect the fuel sending unit for any faults or blockages, as this component directly affects fuel level readings. If necessary, replace the sending unit or gauge itself, ensuring to use compatible parts. After repairs, test the gauge by refilling the tank to verify accurate readings.
because fords suck.
The rev limiter is part of the rotor arm so you need to replace the rotor arm with one that has no rev limiter,but it does have it for a reason !!!! to stop you blowing the engine up
http://www.fiestaguides.co.uk/content/interior.html