answersLogoWhite

0

Wire it as shown in the diagram at the link below.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do I connect a 5Vdc SSR 2A 24Vdc output?

To connect a 5V DC Solid State Relay (SSR) with a 2A, 24V DC output, first connect the control input terminals of the SSR to your 5V DC control signal, ensuring proper polarity. Next, connect the load to the output terminals of the SSR, ensuring that the load is compatible with 24V DC and does not exceed 2A. Finally, provide the appropriate 24V DC power supply to the load, making sure all connections are secure and insulated.


What is Triac?

A triac is a high voltage AC solid state relay it is switched on by applying a dc at the gate it can't be used to switch DC because it stay on while current is flowing even when the gate is low but with AC the current stop flowing when the cycle go zero and will switch of if the gate is low


What types of magnet either permanent or electromagnetic for AC or DC relay?

What types of magnet either permanent or electromagnetic for AC and DC relay?"how DPDT relay works?


Can you connect a 24v dc motor to household current?

You need a DC power supply in order to connect a 24v DC motor to household power.


Can you directly connect 12 V DC 10 A relay to 230 V AC Supply main line?

Yes you can .connect the 230 volt capacitor series with the relay coil.AnswerIf you are referring to the operating coil, then the answer is of course not, as you will be subjecting the coil to nearly 20 times its rated voltage! If you are referring to the contacts, then you need to check the nameplate data for the relay to find out what voltage the contacts are designed to operate at.


Ac relay and DC relay?

what is the meaning of ac relay and dc relay EDIT: a DC relay is simply a coil and core that pulls on an armature. An AC relay usually needs a shaded-pole core (couple of copper loops) to prevent the armature from vibrating at 60 cycles or so. The core, also, is laminated steel like a transformer; so is the armature to help contain the magnetic field. You should not substitute a DC rated relay for an AC , but the reverse should be ok, if voltage and current ratings are the same.


Can you connect an AC source in series to DC source - then what happens to the current under a steady state condition?

With an AC and a DC voltage source in series, the DC voltage can be added to the RMS value of the AC voltage to give the effective voltage.


What does the STATE DC mean?

DC refers to the District of Columbia, which is not a state.


A project in which I would like to use transistors to switch two 10A loads alternately by completely replacing the relays.Is it possible.Can any one suggest a better idea?

If the 10 Amp load is on an AC circuit, you'll need to use a solid state relay. For something that large, such a relay can be quite a bit more expensive than a contact relay. On the other hand, if it's 10 Amps DC, the transistor idea would be great.


What does dc sTANED for?

DC comics is Detective Comics Washington DC is District of columbia DC++ is Direct Connect Dietitians of Canada Dc recordings is Depth Charge


How do you built a mains fail alarm?

Use an intermediary relay that is specifically and only connected to a circuit from a two pole breaker in the distribution panel. Through the N.C. contact of the relay connect your DC alarm system. As long as the power is on the relay stays energized and the N.C. contacts stay open. If a power failure occurs the relay will drop out and close the N.C. contacts. This will close the circuit on the alarm system.


What is Washington DC state postal abbreviation?

DC. The District of Columbia is not part of any state, and uses DC in place of a state.