Just Copy yours nearest friend..
applications of clipper circuit
something to drop the excess voltage across while clipping.
Transfer function is the relationship between output and input of a circuit. In the clipping circuit, the general transfer function is such that the transfer curve Av is less than 1 for passive limiter and greater than 0 to limit the maximum and minimum voltage value.
A: SIGNAL could overshoot a value which can damage the input or output therefore a diode is used to clip these signals to a safe level
In what context? Assuming signal transmission, the main disadvantage of a clipping circuit is that the data transmitted at values outside the circuit's range will be "clipped" (for example, if the clipping value is 20V, and the signal is 23V, the output will be 20V). This is esp. visible with audio circuits, and with electron tube circuits in general. The main advantage, at any rate, would be that a clipping circuit would serve as, say, an overvoltage protection for sensitive devices. But that is a bit of guessing on my part. If the circuit (or circuits) are to be designed properly, I would say that a bridging circuit should be built instead - a circuit that would "shake hands" between two other circuits, bringing their respective levels to a level common for both, or by translating between the two.
As a sinusoidal signal is clipped the waveform approaches a square wave.
NO
A: If an amplifier can be subjected to either input or output overdrive then clipping of both is desirable to insure safety margin and insure amplifier recovery in a minimum time
a+C+BD+B
Because not all the logic gate have what the circuit needs to complete the operation
. Interior and exterior clipping interior clipping what is to be saved is inside the clip window exterior clipping what is to be saved is outside clip window Interior clipping
i am clipping my nails