answersLogoWhite

0

With a Step Down transformer. But you will probably have a hard time finding a 240 volt unit. 120 volts units are readily available.

<<>>

It depends on how big of a transformer that you are looking for. There are many control Transformers in the 50 to 500 VA range that have dual primary and dual secondary. The primary side can be connected to 240 volt or 120 volt and the secondary can be connected for either 12 or 24 volts.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you convert 115 volt into 230 volt?

The only way to do that is with a transformer. They make inline transformers that convert 230 to 115 and they simply plug in inline.


Will a 220 volt ballast operate from a 230 volt source?

Yes, 220 volts is in the same voltage classification as 230 volts.


How Convert 9 volt to 230 volt?

Converting 9 volts to 230 volts would require a pretty hardcore step up transformer (Expensive) and you probably wouldn't have enough current to sustain the load.See discussion page for more information.


Which type of voltage is 230 volt?

The classification of 230 volts is in the low voltage range.


Can you convert a 277 volt ac unit to 230 volt?

There in no quick and inexpensive way of doing this conversion. A transformer would have to be used and this type of winding is not common. 277 volts is the wye voltage of a three phase 480 volt system.


Why 440 volts running capacitor if my ac is 230 volts?

The 440 volts listed on the cap is the maximum allowable voltage the capacitor can handle. You could actually use a 370 volt cap on 230 volts. ANSWER; 230 volts AC can it actually be 644 volts peak to peak . It is 44ov because it must be rectified and sees only 324 volt peak which is withing the 440 volt capacitor handling voltage


How can I get 230 volt single pole wire from my house panel?

In North America you can not obtain 230 volts from just one single pole breaker. The distribution is like this, from a one pole breaker to neutral is 120 volts. From an adjacent breaker to neutral is 120 volts. From the adjacent breaker to adjacent breaker (breakers situated beside each other) the voltage will be 230 volts.If you want to incorporate a 120 to 230 volt transformer into the circuit you can obtain 230 volts. The primary side of the transformer will be connected to the 120 volt circuit and the secondary side of the transformer will output 230 volts. The transformer must be sized to the load amperage or the load wattage of the connected 230 volt load.


Which is the device that convert Minus 48Dc volt to 230 volt Ac?

That is called an inverter.


How do you obtain a 230 volts single phase supply from a 400 volts three phase four wire supply?

400 volt three phase on a grounded system is 230 volt single phase, with each phase 120 degrees apart. So, if you have a 400 volt, three phase four wire service (grounded service), you can pull one phase off and reference to the neutral for 230 volt service. Note this may not allow 115 volt service, unless there is also a center tap for each phase.


What is the maximum volts that can be used on a 208 230 volt motor?

You should not go above 240 volts for that type of motor.


Can 400volts heater element get supply from 230 volts?

No, a 400 volt heater element cannot be safely operated on a 230 volt supply. To avoid damaging the element and potential safety hazards, it is important to match the voltage rating of the heater element with the supply voltage.


How do you convert 230volt to 1 kilovolt?

To convert 230 volts to 1 kilovolt, you multiply by 0.001 (1 kilovolt = 1000 volts). Therefore, 230 volts is equal to 0.23 kilovolts.