You'll need an adapter. Contact one of the adapter manufacturers such as Advanced Adapters or similar.
c4
The C4 will bolt up to the 302 with the correct bell housing.
sure, it's the same thing.
Depending on year it can be in transmission or under the dash on your stearing column. I know the AOD's and C4's where internal was plug on left side of trans had 4 or 5 leads in it. .
Probably a turbo 350 trans. This is a three speed trans. The way for you to check is to look at the trans pan. look up a picture of a turbo 350 trans and compare it to your trans pan.
The LS1 was not a 350... and what was your question again..?
350 hp
look at the trans pan if its a c5 it will be square with i think 13 bolts the c4 has the same pan i heard the c5 is 7in long and the c4 is 6 something
Yes, so a torque converter simply fit thm 350 trans.
YES, if it's the stock c5 pan. The stock c5 pan has a hump in the middle of the pan for the transmission oil pickup, that is the only difference. However if it is changing or switching pans you are doing, there is some wiggle room. Since the c5 pan has the hump and the c4 pan is flat, you can put a c5 pan on a c4 trans. but you can't put a STOCK c4 pan on a c5 trans. Why did I emphasize stock? because if you can get a deep enough aftermarket c4 pan think it has to be deeper than 4 inches) it will clear the c5's oil pickup. So in other words if you get a deep enough c4 pan (deeper that 4 in. I think...) it will fit on a c5.
a ford c4 transmission 1975 or so thunderbirds mustangs maverics and trucks have these.
Yes