Fusing is based on wire size and demand load.
The fusing current of a wire is the current that will cause the wire to overheat and melt, which will break the circuit, acting like a fuse.
The only way an Inverter could overload a circuit would be on the supply side. The fusing/protection for the inverter is incorrect.
(this is the circuit)
Damage from short circuits can be reduced or prevented by employing fuses, circuit breakers, or other overload protection, which disconnect the power in reaction to excessive current
There are two kinds of circuit closed circuit and open circuit
The fusing on this ball has separated.
By reading the manual cocerning circuit amperage
Fusing machine
Fusing depends on the load characteristics. If the load is a motor then the fusing is higher to allow the motor inrush to start the motor and not trip the fuse protection. Resistive loads are usually fused at the wire ampacity allowed for that load current.
The circuit should be protected by a 15 A breaker.CLARIFICATION:If the wires and other components are capable of handling 15 amps (14 Ga wire or larger), you can safely protect the circuit with a 15 amp breaker. If the circuit is a non-standard lighting device for something other than typical residential application, you should contact an electrical engineer to help you determine the proper wiring and breakers.
Inside the Sun, it is mainly hydrogen-1 fusing into helium-4.
Need to identify what type of circuit you're referring to.