0
How do you disable the alarm for the seat belt in a 2007 Jeep Commander?
T3b0n3
The Enhanced Warning System (BeltAlert) can be enabled
or disabled by your authorized dealer or by
following these steps:
NOTE: The following steps must occur within the first
60 seconds of the ignition switch being turned to the ON
or START position. DaimlerChrysler does not recommend
deactivating the Enhanced Warning System
(BeltAlert).
1. Turn the ignition switch to the OFF position and
buckle the driver's seat belt.
2. Start the engine and wait for the Seat Belt Warning
Light to turn off.
3. Within 60 seconds of starting the vehicle, unbuckle
and then re-buckle the driver's seat belt at least three
times within 10 seconds, ending with the seat belt
buckled.
NOTE: Watch for the Seat BeltWarning Light to turn on
while unbuckling and off while re-buckling the seat belt.
It may be necessary to retract the seat belt.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where the relay is for the alarm on a 1997 grand Cherokee jeep and where the alrarm is located?
i need to disable jeep factory alarm 1997 cherokee
How do I disable the alarm on my 1996 Jeep GC?
Get a big hammer and beat it.
How do you disable the alarm on 99 jeep grand Cherokee?
The factory alarm can not be disabled, only repaired if malfunctioning.
How do you disable the alarm for the seat belt on a 2011 Jeep compass?
wear the seat bealt
Where is the radio fuse in 2007 jeep commander?
No
How do you dislocated a alarm from a liberty jeep both where is it and how to disable it my jeep wont start everything is working well i was told it my alarm that stop my car from starting?
Please rewrite. This is not a question and makes little sense.
2004 Jeep Grand Cherokee Larado and the alarm is set and no remote how do you disable it so you can start it?
You will have to uninstall the alarm and rewire the vehicle. It is likely the ignition wires are run through the alarm.
What makes a 1989 jeep Cherokee run for a few seconds then kill?
Is it possible that the Jeep is a Laredo with an alarm. My jeep did the same thing after I installed a new starter. What I had to do was close the driver side door, lock it, and then unlock it to disable the alarm. Hope this helps.
How do you disable a 91 Jeep Cherokee Laredo's factory alarm?
pull the 15 amp fuse in the fuse box.
What is the curb weight of 2007 jeep commander?
Around 4000 lbs
Where is the fuse for a factory alarm on a 1993 Grand Cherokee Limited?
on my 1993 jeep GCL i removed fuse 6 and 7 from the fuse box to disable my alarm i hope this helps
How do you disable the seat belt alarm in a 2005 Jeep Liberty?
Put your seatbelt on like the laws says and common sense begs you to do.
