Ford Ranger

How do you disarm an anti-theft system on a 1998 Ford Ranger?

293031

Top Answer
User Avatar
Wiki User
2014-09-18 00:22:53
2014-09-18 00:22:53

You can disarm your 1998 Ford Ranger antitheft system by removing the antitheft system fuse. The fuse is located in the fuse box.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how to dis arm a theft system on a 1998 oldsmoble or how to rest it

User Avatar

how do reset a 1998 chevey cavalier antitheft system if it want start and the anti theft light is on

User Avatar

The easiest way to reset the antitheft system in your 1998 Mercury is to remove the antitheft system fuse. Keep the fuse out for 10 seconds and then replace it to its original position.

User Avatar

To disarm the alarm on the 1998 Ford Contour, simply turn on the ignition using the vehicle's key. You can also disarm the alarm using the key fob.

User Avatar

Turn the key forward for ten min. then shut the key off then try to start it.

User Avatar

This forum is Not intended to answer questions that are questionable as to there use either legal or illegal and or immoral. If the dealership wishes to give you the information that is their decision.

User Avatar

I'm have the same problem with my 2000 regal, if you figure it out email me please donk923@AOL.com

User Avatar

While the alarm is beeping, turn the ingnition to on position push the button in then take the key out.

User Avatar

Insert the key in the drivers door and unlock, lock. unlock again. That is how a factory alarm system is bypassed in case your battery dies in your remote.

User Avatar

Air bag code " 24 " - System Disarm Failure or Internal Diagnostic Monitor Fault

User Avatar

Remove the fuse under the hood its in a fuse box on the passenger side under the hood

User Avatar

On a 1998 Ford Ranger ( fuse # 17 ) is a ( 25 amp ) fuse for the cigarette lighter

User Avatar

My Ford Ranger is a 1998 4.0 ltr V6.

User Avatar

What is the timing for a 1998 ford ranger 2.5l

User Avatar

There is no kill switch on a 1998 Trans Am.

User Avatar

unhook the battery cables for 10 minutes.

User Avatar

The 1998 Chevrolet Camaro factory alarm system is equipped with its own fuse. The location of the fuse can be found on the inside cover of the fuse box.

User Avatar

what is the axle gear ratio for a 1998 ford ranger 4x4 4.0l?

User Avatar

No, the cab was lengthened in the 1998 model year.

User Avatar

need locations of steering column brackets on a 1998 ford ranger

User Avatar

The COOLANT SYSTEM CAPACITY ( 50/50 mix of antifreeze and preferably distilled water ) is 10.2 quarts ( 9.6 liters ) for a 1998 Ford Ranger 3.0 L V6 WITH air conditioning

User Avatar

On a 1998 Ford Ranger : The evaporator core for the air conditioning system is inside the plastic case ( that also holds the heater core ) located behind and below the glove compartment in the dash on the passenger side

User Avatar

You disarm the security by unlocking the doors with a key or remote.

User Avatar

The wheelbase of the 1998 Ford Ranger Supercab is ( 125.7 inches ) according to the owners manual


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.