0
What else can I help you with?
How to change air filter in 95 Ford Taurus you located air filter compartment open clips but cannot move cover Thanks?
normaly, once you disconect all the clips(front and back) AND DISCONECT THE HOSE, THE COVER SHOULD LIFT RIGHT UP.LOOK AROUND IT AND MAKE SURE YOU DIDN'T MISS ANYTHING.
Where can you find a light switch wiring diagram for a 74 Plymouth duster?
If you mean which wire goes where on the back of the light switch assembly, google MSD's free online instructions for wiring their kits It'll show the clips on the switch and the factory wire colours and where the go
How do you remove the dome light cover of jaguar x-type?
Pull the front down first, just four clips hold it up, might come down hard, once the fronts put slide the back foward and disconect the plug
Where is the fuel sensor reset switch on a 97 Honda CR-V?
disconect the earth off the battery for 30 mins ( DONT FORGET TO FIND THE CODE FOR YOUR RADIO IF IT NEEDS ONE , BEFORE YOU DISCONECT THE BATTERY )
Where is the check engine light reset on a 1990 Geo Tracker?
AnswerHi, If your vehicle has a switch, it should be under the dash, on ther left side on the steering column support or to the left of the speaker. The lamp can be reset by moving the switch up then down. If the light remains on then check the system. Steve H. or DISCONECT the battery for 30 sec then reconect
How do you replace backup light switch on 1998 Toyota 4runner with manual transmission?
get under vehicle on passenger side. look at trans. disconect sensor. (you cant miss it) unscrew and replace with new one cost $28
How do you replace ford galaxy brake light switch?
To replace the brake light switch on a Ford Galaxy, first, disconnect the vehicle's battery to ensure safety. Locate the brake light switch, typically found near the top of the brake pedal assembly. Remove any clips or screws securing the old switch, disconnect its wiring harness, and then install the new switch by reversing the process. Finally, reconnect the battery and test the brake lights to ensure proper operation.
How do you replace brake light switch on a 1994 Mercedes C280?
To replace the brake light switch on a 1994 Mercedes C280, first disconnect the negative battery terminal to ensure safety. Locate the brake light switch, which is typically mounted on the brake pedal assembly. Remove the electrical connector and the switch by unscrewing it or releasing any clips holding it in place. Install the new switch, reconnect the electrical connector, and reattach the battery terminal before testing the brake lights.
How do you remove the light switch on an Audi TT?
To remove the light switch on an Audi TT, start by using a flathead screwdriver to carefully pry off the trim surrounding the switch. Once the trim is removed, you can access the screws or clips holding the switch in place. Unscrew or unclip the switch and gently pull it out, disconnecting any wiring harnesses attached. Be sure to handle all components with care to avoid damaging them.
Where is the Neutral safety switch located on the 1998 Wrangler 25L with manual trans?
Clutch pedal lever. SWITCH IS AT THE TOP OF CLUTCH PEDDLE BUT THE OVER RIDE FUSE IS # 20 ON FUSE PANEL REPLACING THE FUSE WILL DISCONECT SWITCH.
How do you remove light switch on 2003 1.4 fiesta?
To remove the light switch on a 2003 Ford Fiesta 1.4, first ensure the vehicle is off and the keys are removed from the ignition. Use a flathead screwdriver to gently pry off the trim surrounding the switch, then locate the retaining screws or clips securing the switch itself. Unscrew or release these fasteners, then carefully pull the switch out of the dashboard. Disconnect the wiring harness from the back of the switch to fully remove it.
How do I get the ABS light off on a 94 Trans-Am?
disconect both battery cables for about 30 minutes to reset
