where do i find the thermostat for 99 cavalier
My 1997 Chevy Cavalier with 2.2L motor used a 15mm socket.
30 mpg hwy
The flasher for a 99 Cavalier is under the drivers side of the dash. The flasher is mounted at the top of the emergency brake pedal.
No...the 99 has 2 bulbs and the 01 has 1 bulb
I found the answers to a lot of my questions about my 99 Cavalier by buying a Chilton's manual for the car.
The cost to replace the clutch in a 1999 Chevy Cavalier ranges from $100 to $180. This depends on part brand and labor costs.
The 1997 and 1999 Chevy Cavalier transmissions are exactly the same. The transmissions, transmission linkage, and transmission mounts are identical.
probably but it will sure start stinking.
could b your abs sensor in you front cv joint`s
It depends on which engine your trying to swap. The 2.2L OHV engine will work in a 99 from a 2002 because it was the same engine. But if it's a Z24 model the 2.2L DOHC engine will not fit a 99 because the 99 used the old 2.4L Quad 4 in the Z24 models and some LS sedan models.
what other hard tops from convertables will fit a 99 Chevy cavalier
There is probably a leak in the heater core which is under the dash on the firewall.
i got a quote for 380 dollars with a second hand starter
I have a 99 cav and it get 28 1/2 miles to the gallon
as long as the transmissions are the same yes but there may be a wiring difference as well as cv joint size difference To make this transmission work you would have to change all the electrical from the 2003 and put it into the 99 model year. This would be a very big job that most transmission shop will not touch
In my 99 cavalier it means to look at gauges and check to make sure they are reading correctly. Mine goes on when I need fuel. Dummy light is what they are called.
i cna tell you 97 98 acheva 96-99 cavalier 96-99 sunfire 96-98 grand am it has to br a 2.4 engine tho because the starter is in a different place
A 1999 Cavalier does not use Freon as a refrigerant.
Remove the tire and wheel from your 1999 Chevy Cavalier. Remove the brake spring and the caliper. The brake pads will come off. Tap on the rotor with a hammer or mallet. The rotor will slide off. Reverse the process to install the new brakes and rotor.
It should only be an hour or so job. The labor would be around 100 dollars as long as there aren't any problems. A water pump can be picked up new for around 26 dollars.