venting them high enough to dissipate.
it is to help with the heat in are house
Heat load is calculated by the following equation Q=m*cp*deltaT m=mass flow rate cp=specific heat deltaT=difference in temperature
There is a thermoelectric generator between the heat sink and combustion chamber. The generator produces power which, in turn, spins the fan(s) in the unit.
If the generator is to maintain the same rpm and power output, then a heavier load will increase the diesel consumption. The revolutions per minute the generator runs will increase as the load increases, thereby resulting in an increase in diesel consumption to maintain the high rpm. A Generator has a governor which attempts to maintain frequency at 60 Hz for North America. For the generator to increase the power output at the same frequency, the governor will increase the fuel and air to the engine. The fuel consumption will not be linear because of the curves associated with the particular engine. The fuel to KWH is know as the heat rate curve for the generator.
In case of vapour compression cycle (VCC) the COP is given by (desired effect / work input). in the other words it can be defines as what we want and what we are paying for that... so in VCC the paying amount is very less as due to low temperature difference that why its value is more than 1. but in case of vapour absorption system the COP is given by (heat taken by evaporator/ heat given to generator). the heat input taken by evaporator is less as compared to heat given to generator.. that why its COP is less than 1......
If they just use an ordinary generator that exhausts its waste heat into the sky, like a conventional power plant, there is no advantage. But if the manufacturer uses a combined heat and power (CHP) system there is a benefit because the waste heat from the generator is used to provide space-heating in the factory, which gives a saving in energy costs.
a generator would prodution the heat to a house.
heat
Installing fiberglass batting will completely eliminate heat loss.
actually more, due to losses and inefficiencies in its own mechanism. the exhaust heat is the sum of the heat absorbed plus this "waste" heat from its mechanism.
in power lines, the best way to eliminate heat transfer is to transport energy with a high voltage and low current.
Stainless steel exhausts are expensive but last a long time; they do not rust away like regular steel exhausts. Stainless steel exhausts are populat on custom, prestige and kit cars. A good staimless exhaust will last the lifetime of a car and never need replacing. It will, however discolour form the heat!
Heat from nuclear energy is used to produce steam to drive a turbine/generator
it is to help with the heat in are house
we should use highly heat energy absorbing bodies like black bodies to absorb the heat energy...this energy is provided to water and water will be converted into steam which will run the generator
Air Conditioning, heat, ect. Air Conditioning, heat, ect.
yes but if you breath in the fumes it may give you mouth and or throat cancer :)