depend whether it is a ROM or a RAM disc. If it al ready has some preprogramed infomation, then you can not delete it but if it is just a black disc then go for it.
BTW im 12, call me a nerd if you will but will that get you anywhere? No, i didn't think so.
i tried to drag from flash drive to cd , can ot work cd is empty
download the music on your computer and then put an empty cd in and click on the button burn and it will put the music into the cd
I would suggest that you check the drivers for your CD ROM Drive and if it is connected properly. You should also make sure you are using the correct type of CD for your Drive.
Try grounding the radio to your car. It's that empty hole in the back that says GND.
a. Make sure the CD comes from a trusted sourceb. Get supervisory approvalc. Contact technical support and have them perform the installationd. Make sure the CD tray is empty
a. Make sure the CD comes from a trusted sourceb. Get supervisory approvalc. Contact technical support and have them perform the installationd. Make sure the CD tray is empty
to do this you must first save what ever is on the floppy disc onto your computer or laptop and then transfer the file from the floppy on to an empty CD disc and then it is done
This may be due to a bad sensor. It may be the sensor needs to be replaced. It may also be that the sensor needs to be cleaned.
A blank CD is rather like a blank sheet of paper; so as information is written to it the blank area is replaced with the written information.
I understand it was an op. I need to know where they already wired to install one? The unit in the front shows CD on it. The area in the truck is empty.
Yes you will need a special software to burn music onto CDs. The CD has to be bigger than the music you are burning. You just put an empty CD into your PC or Mac then it will say burn CD.
I would take it and my receipt back to the store.