you buy more hose and you make it longer look how it bade and finmd a way to getting around without blocking the hose
38-44 psi with pressure regulator vacuum hose disconnected and plugged
you have a broken air intake hose the large plastic line going to the air filter
Follow the link and buy the bookhttp://www.themotorbookstore.com/toyota-pickup.html
It should be on the cylinder head where the top hose attaches.
Look in the removable housing at the engine end of the upper radiator hose
To change the bottom radiator hose on a 1987 Toyota 1 Ton pickup, first ensure the engine is cool and then drain the coolant from the radiator by opening the drain valve. Loosen the hose clamps at both ends of the bottom radiator hose and remove the old hose. Install the new hose by securing it with the clamps, then refill the radiator with coolant and check for leaks. Finally, run the engine to ensure proper circulation and check the hose connections again.
The best place to find a diagram of hoses for a 1992 Toyota pickup power steering is in the owner's manual. Most auto part stores will also have a diagram of the hose.
The Thermostat is located to the pasenger side of the Valve cover, just folow your upper radiator hose back and it will be in the housing that the hose conects too.
How do you replace the fuel filter located on a 1990 Toyota Camry?" 1990 Toyota Camry fuel filter is located under the air intake hose, disconnect one end of the hose from the throttil body and other end from air filter box.And move the hose to the side. Now you could see the fuel filter. You need to use two open end range to disconnect the fuel filter.I believe it is 17 mm, not sure.Don't forget to put a piece of rag under the fuel filter, because you will spill some fuel.
First jack up the truck and remove the rear whee, then disconnect the fuel hose and breather hose to the tank. Then loosen the metal bands holding the fuel tank in place. The unscrew the five nuts holding the sending and gauging unit in place, after disengaging the wiring to it. Replace the unit, connect the wires, fasten the nuts, fasten the fuel tank metal bands, then fasten the hoses, make sure there are no leaks.
high side would be hose that is the smallest and low side port is the bigger one
locate top radiator hose where it connects to the engine. remove hose from engine. the pipe the hose came off of houses the thermostat. ther are 2 bolts holding it youll need a ratchet with an extention and 12 millimeter socket